Abstract:As a ferroelectric material with spontaneous polarization, BiFeO 3 (BFO) has been considered as a promising photoelectrode material in recent years, but its photoelectrochemical (PEC) properties still need to be further improved. In this work, the Au/Nd-doped BFO (Au/BNFO) thin film photoelectrode was successfully fabricated by combining Au nanoparticles (NPs) loading and Nd doping, aiming to improve the PEC performance of the BFO photoelectrode. To fabricate the Au/BNFO thin film photoelectrodes, the BNFO thin film was firstly prepared by sol-gel spin coating and Au NPs was then photodeposited on the surface of BNFO thin film. The PEC test results reveal that the photocurrent density of Au/BNFO at 1.2 V (vs. Ag/AgCl) was 0.63 mA cm -2 , which was much higher than pure BFO (0.13 mA cm -2 ), BNFO (0.17 mA cm -2 ) and Au/BFO (0.31 mA cm -2 ), and the transient photocurrent density measured upon on-off light illumination was ca. 3.8, 1.8 and 1.2 times that of BFO, BNFO and Au/BFO, respectively. This indicates that the PEC properties of the BFO photoelectrode could be greatly improved by the synergistic effect of Au NPs loading and Nd doping. The improved PEC properties of the Au/Nd-BiFeO3 photoelectrode could be attributed to the synergistic effect of the combination of Au NPs and Nd doping, which could increase the carrier concentration, promote the charge separation and inhibit the recombination of photogenerated carriers, as confirmed by the Mott-Schottky (MS), electrochemical impedance spectra (EIS) and photoluminescence (PL) spectra.

Enhancement of Photoelectrochemical Performance in Ferroelectric Films Via the Introduction of an Au Buffer Layer

Ferroelectric Polarization-Induced Performance Enhancements in BiFeO3-Based Photoanodes for Photoelectrochemical Water Splitting

Tunable photoelectrochemical performance of Au/BiFeO<sub>3</sub>heterostructure

Ferroelectric enhanced photoelectrochemical water splitting in BiFeO3/TiO2 composite photoanode

Modulating built-in electric field via Bi-VO4-Fe interfacial bridges to enhance charge separation for efficient photoelectrochemical water splitting

Surface ferroelectric polarization promotion on photoelectrochemical oxygen evolution by transparent P(VDF-TrFE)

High Performance Ferroelectric‐modulated Photoelectrodes by Using Grid Charge Collector

Understanding the impact of Bi stoichiometry towards optimised BiFeO3 photocathodes: structure, morphology, defects and ferroelectricity

Synthesis and SPEF-Induced Enhanced Photoelectrochemical Performance of the BaTiO3@α-Fe2O3 Ferroelectric Heterojunction

High Performance BiFeO3 Ferroelectric Nanostructured Photocathodes

Interfacial Binding-Enhanced Charge Transport for CoFe-MOF/Fe2O3 Photoanodes with Excellent PEC Performance

Improving the charge properties of the WO 3 photoanode using a BiFeO 3 ferroelectric nanolayer

Impact of ferroelectric polarization on different semiconductors for photoelectrochemical application

Fabrication and Kinetic Study of A Ferrihydrite-Modified Bivo4 Photoanode

Bipolar charge collecting structure enables overall water splitting on ferroelectric photocatalysts

Enhanced Internal Field of Bi4NbO8Cl Ferroelectric Photocatalyst to Promote Charge Separation Via Constructing Crystal Plane-Dependent BiOI Dielectric Layer

Insights on the Origination of Ambipolar Photocurrent of Ferroelectric and the Improvement of Photoanodic Current

Decoration of BiVO4/ZnO Photoanodes with Fe‐ZIF‐8 to Simultaneously Enhance Charge Separation and Hole Transportation for Efficient Solar Water Splitting

Synergistic Effect of Nd Doping and Plasmonic Au Nanoparticles on BiFeO 3 Thin Film Photoanodes for Enhancing Photoelectrochemical Performance

Enhanced Solar Water Splitting by Swift Charge Separation in Au/FeOOH Sandwiched Single Crystalline Fe$_2$O$_3$ Nanoflake Photoelectrodes

Ni doped amorphous FeOOH layer as ultrafast hole transfer channel for enhanced PEC performance of BiVO4