Optimization of Grain Layer Thickness in the Design of Solar Grain Dryer through Simulation

Jeremiah Kiplagat,George Owino

2015-01-01

Abstract:Forced convection solar dryers, utilizing solar driven fans, may be used to improve ventilation, and to achieve an optimum drying air velocity in grain dryers. However, without use of the appropriate grain layer thickness, the heated air may not be able to successfully penetrate the grain to facilitate drying. Also, too many grain layers placed in the drying cabinet may prevent air from flowing up the entire drying cabinet. The appropriate grain layer thickness and maximum number of drying trays are therefore factors that are crucial in sizing a solar drying cabinet. However, their determination, without use of simulation, would require troublesome development stages, involving trial and error and continued testing, a process which would be expensive and time consuming. This study applied simulation using Comsol Multiphysics Software for their determination, hence enabling the sizing of a dryer cabinet to facilitate sufficient and effective aeration of the grain for optimization of the drying process. It was found that the maximum grain layer thickness that can allow penetration by air is 100 mm. It was also found that the maximum number of grain layers that should be dried for effective aeration was 4.