Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

An adaptive feed-forward vibration control algorithm for multiple periodic disturbances of unknown frequencies

An Adaptive Control Algorithm for Harmonic Cancellation in Multiple-Input Multiple-Output Vibration Systems

Research on Frequency-Selective Output Constraint Algorithm for Active Vibration Control

An Adaptive Feedback Vibration Control Algorithm

A novel adaptive control algorithm for the rejection of harmonics in a standard vibrator

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Frequency behavior analysis for predictive control with adaptive disturbance model

Periodic Disturbance Rejection Method Using Iterative Learning Predictive Function Control.

Three-axis vibration control based on drive spectrum modified iterative control algorithm

Virtual feedforward control for asymptotic rejection of periodic disturbance

An Adaptive Feedforward Method in Active Vibration Control for the Propulsion Shafting System

Adaptive Vibration Suppression of Time-Varying Structures with Enhanced FxLMS Algorithm

Development of an Effective Feed-Forward Control Method for Active Antenna Cancelation

Multi-frequency periodic vibration suppressing in active magnetic bearing-rotor systems via response matching in frequency domain

A Switching Periodic Adaptive Control Approach for Time-Varying Parameters with Unknown Periodicity

An Active Vibration Isolation Control Method under Excitation of Multi-Line Spectra

Active Vibration Control for the Time-Varying Systems with a New Adaptive Algorithm

Fractional Order Adaptive Feed‐Forward Cancellation for Periodic Disturbances

On-Line Adaptive Identification And Cancellation Of Periodic Disturbance With Unknown Parameter

Dual-Stage HDD Disturbance Cancellation Based on an Efficient Adaptive Feedforward Compensation Algorithm

An Enhanced Adaptive Notch Filtering Method for Online Multi-Frequency Estimation from Contaminated Signals of a Mechanical Control System