Abstract:The fully biodegradable polymer stent is considered as the fourth-generation vascular implant with good biocompatibility and long-term therapeutic potential. It has attracted much attention because it overcomes the disadvantage of the permanently implanted metal stent. However, compared with the metal stent, its mechanical properties are slightly inferior, which is an urgent problem. Based on previous studies, fully biodegradable polymer stents are prone to experience cracks and damage in large deformation region during the crimping and expansion process. The large deformation region is mainly located at the ring bend of the stent. We supposed that these damages are the leading causes of weakening the mechanical performance of polymer stents and are mainly affected by the crucial deformation region. For this purpose, this work studies the relationship between different crucial deformation regions and the mechanical performance of the polymer stent. Firstly, the volume of the crucial deformation region is improved by increasing the ring width. Although the radial strength of the stent is enhanced with the increase in ring width, the radial stiffness also increases, and correspondingly, the flexibility of the stent decreases. To obtain acceptable comprehensive mechanical performance, two types of slotting design in critical deformation region were proposed. The proposed slotted stent with a bulge has sufficient radial strength and low radial stiffness, having a good radial support capacity and flexibility. In other words, the proposed stent has improved the radial support without sacrificing flexibility. Overall, different crucial deformation regions cause different degrees of damage to the stent during crimping and expansion, which affects the mechanical properties of the stent. Reasonable structural design of the crucial deformation region is the key to adjust the comprehensive performance of the stent.

Study on Mechanical Properties of Curved Vascular Stent after Crimping

Computational biomechanics and experimental verification of vascular stent

Finite element analysis of braided dense-mesh stents for carotid artery stenosis

Finite Element Analysis on the Crimped Mechanical Behavior of Coronary Stents

The FEM simulation of mechanical properties characterization of the stent under the quasi-static loading/unloading

Stent expansion in curved vessel and their interactions: a finite element analysis.

Influence of Work Hardening on the Performance of Stents

Study on the bending behavior of biodegradable metal cerebral vascular stents using finite element analysis.

[Finite Element Analysis of the Mechanical Property of the Resistance to Compressing of the Coronary Stent].

Influence of Crimping on the Performances of Balloon Expandable Stents

Focus on the Crucial Deformation Region to Adjust the Comprehensive Performance of Poly (L-Lactic Acid) Stent.

Study on Flexibility of Intracranial Vascular Stents Based on the Finite Element Method

Mechanical Property Analysis of Nitinol Defective Stent under Uniaxial Loading/Unloading

[In Vitro Experimental Study on the Mechanical Properties of Biodegradable Polymer Stents].

Finite Element Simulation of Coronary Stent Expansion Process

Mechanical Response of Cardiovascular Stents under Vascular Dynamic Bending

[Structural Design and Biomechanical Numerical Analysis of Body-Fitted Stent in Stenotic Vessels].

Numerical and Experimental Study of Radial Support Capacity of Intravascular Stent

Computational and Experimental Investigation into Mechanical Performances of Poly-L-Lactide Acid (PLLA) Coronary Stents

Nonlinear Finite Element Analysis for Compression Behavior of Intravascular Stents

Mechanical Behavior of Polymer Braided Stent at Rapid Radial Loading