Abstract:This paper studies the fault analysis method and fault characteristics of valve-side winding fault of converter transformer in line-commutated-converter high-voltage direct-current (LCC-HVDC) system. The time periods are divided according to the valve conduction state within one power frequency cycle, and these time periods are classified based on the common features. For each type of time period, the flow path of the fault current is analyzed, the circuit equation is established, and the current on both sides of the transformer is solved. By combining the various time periods together, the expressions of the currents on both sides of converter transformer in one power frequency cycle after fault are obtained. The fault characteristics of the valve-side winding fault are studied based on the expressions, and the differences between them and ordinary transformer are pointed out. The research results show that when a single-phase grounding fault occurs in the valve-side winding of the low-voltage (LV) bridge converter transformer in LCC-HVDC system, both the grid-side current and the valve-side measured current contain a lot of harmonics, which will affect the operating characteristics of differential protection. Finally, a simulation model is built using PSCAD to verify the fault characteristics obtained from analysis. These works provide a theoretical basis for analyzing the action characteristics of converter transformer protection when the valve-side winding fault occurs and studying the new protection principle. © 2017 Elsevier Inc. All rights reserved.

Serious Fault Identification for VSC-HVDC Converters

A Comparative Study of Two Diagnostic Methods Based on the Switching Voltage Pattern for Igbt Open-Circuit Faults in Voltage-Source Inverters

Fault Diagnosis for VSC-HVDC Using Wavelet Transform

A Recovery Method for HVDC Systems Following AC System Faults

Research on Fault Identification of Hybrid Multi-Feed High-Voltage Direct Current System Based on Line Commutated Converter and Voltage Source Converter

Fast Transistor Open-Circuit Faults Diagnosis in Grid-Tied Three-Phase VSIs Based on Average Bridge Arm Pole-to-Pole Voltages and Error-Adaptive Thresholds

DC side short-circuit fault analysis of VSC

Fault Identification of Winding Axial Displacement and Inter-turn Short Circuit for UHVDC Transformer

Transient Modeling and Analysis of VSC Based DC Microgrid During Short Circuit Fault

Study on valve-side winding fault characteristics of converter transformer in LCC-HVDC system

Improved Identification Method and Fault Current Limiting Strategy for Commutation Failure in LCC-HVDC

Modeling and Overvoltage Suppression Analysis of Grid-connected Converter with VSG Control Strategy under Commutation Failure

An Average Model-Based Transistor Open-Circuit Fault Diagnosis Method for Grid- Tied Single-Phase Inverter

A Method to Calculate Short-Circuit Faults in High-Voltage DC Grids

Topology, Control and Fault Analysis of a New Type HVDC Breaker for HVDC Systems

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

Research on Single-Phase Grounding Fault Protection on the AC Side of VSC-HVDC Systems Considering Third Harmonic Modulation

A Faulty Pole Detection Method for the VSC-HVDC System Based on the Aperiodic Component Energy

Impedance Phase Based Active Injection Protection for Radial VSC-HVDC Grid

A Hierarchical Identification Method of Commutation Failure Risk Areas in Multi-Infeed LCC-HVDC Systems