Abstract:The mechanisms controlling the dependence on low-velocity flow of the piloted ignition of a solid material under external radiant heating is investigated through a numerical modeling. The poly (methyl methacrylate) (PMMA) was used as the fuel. The objective of the present study is to gain insight into the intrinsic ignition mechanisms of a solid fuel, as well as to gain a more comprehensive understanding of the dynamical characteristics of the ignition process near the extinction limit. For this purpose, a two-dimensional numerical model has been developed using the Fire Dynamic Simulator (FDS5) code, in which both solid-phase and gas-phase reactions are calculated. Two radiant heat flux, which are 16 and 25 kW/m 2 were studied, and an external air flow was varied from 3 to 40 cm/s. The simulation results showed that transient gas reaction flashed before a continuous flame was attached to the sample surface for gas flow velocities lower than a critical value. As the flow velocity is reduced, the flashing time, which is defined as the time when any flame is seen above the sample surface, decreases, while the duration of flashing increases. The solid surface temperature and mass flow rate increase rapidly during flashing. The ignition time, which is defined as the time when a continuous flame is attached to the fuel surface, decreases, reaches a minimum, and then increases until ignition cannot occur. Mechanisms were considered to explain the ''V-shaped" dependence of ignition time on flow-velocity, and two regimes were identified each having a different controlling mechanism: the mass transport regime where the ignition delay is controlled by the mixing of oxygen and pyrolyzate; and the heat transfer regime where the ignition delay is controlled by changes in convection heat losses and critical mass flux for ignition. With the decrease of the airflow velocity, the critical mass flux shows a trend of decreasing and then increasing, which is dominated by the mixing of the pyrolyzate and the oxidizer, while the critical temperature monotonically decreases, which is dominated by a reduction of the net heat flux at the fuel surface. The results provide further insight into the ignition behavior of solid fuel under low-velocity flow environment, and guidance about fire safety in microgravity environments.

Mass Loss Prediction of Inclined Fuel Combustion Using Variable B-number Theory

Experimental Study of Flame Spread over Thermally-Thin Inclined Fuel Surface and Controlling Heat Transfer Mechanism under Concurrent Wind

Experimental Investigation and Theoretical Analysis of Flame Spread Dynamics over Discrete Thermally Thin Fuels with Various Inclination Angles and Gap Sizes

On the orientation effect on the flame spread over discrete fuel using a mass-transfer number

A Mixture Fraction Approach to Predict Polymer Burning

Modelling of flame spread over biomass fuel arrays with various inclined angles and spacings

An LBM-FDM Coupled Numerical Model for Ignition and Transient Downward Flame Spread over Solid Fuel

Flamelet Tabulation Methods for Solid Fuel Combustion with Fuel-Bound Nitrogen

Flame Structure Analysis and Flamelet Modeling of Turbulent Pulverized Solid Fuel Combustion with Flue Gas Recirculation

Experimental Study on the Buoyant Turbulent Diffusion Flame Height of Various Intermittent Levels

Transition of heat transfer mechanism of concurrent flame spread over discrete fuels

Heat and Mass Transfer Mechanisms During Unsteady Flame Spread Process along Inclined Surface under Wind

A Comprehensive Study of Flamelet Tabulation Methods for Pulverized Coal Combustion in a Turbulent Mixing Layer—part II: Strong Heat Losses and Multi-Mode Combustion

Morphological Characteristics of Non-Vertical Turbulent Jet Flames: Experimental Investigation and Analytical Model

Prediction of Thermal Radiation Received by Vertical Targets Based on Two-Dimensional Flame Shape from Rectangular N-Heptane Pool Fires with Different Aspect Ratios

Numerical Simulation of Microgravity Flame Spread over Solid Combustibles

Experimental and theoretical research on burning rate and radiative heat flux of thin-layer fuel with lateral continuous leakage

Numerical Study on Opposed-Flow Flame Spread over Discrete Fuels – the Influence of Gap Size and Opposed-Flow Velocity

Approximate Analytical Solutions for Transient Mass Flux and Ignition Time of Solid Combustibles Exposed to Time-Varying Heat Flux

Surface inclination effects on heat transfer during flame spread acceleration based on FireFOAM

Numerical Study on Pilot Ignition of a Thermally-Thick Solid Fuel with Low-Velocity Airflow in Microgravity