Study on Fractured Rock-Like Materials for Geomechanical Model Test Based on 3D Printing Technology

K Zhang,Y R Liu,M H Xiao,J T Chen,Q Yang

DOI: https://doi.org/10.1088/1755-1315/861/2/022031

2021-01-01

IOP Conference Series Earth and Environmental Science

Abstract:The geomechanical model test has been verified to be an important way to solve some puzzling geotechnical issues. So far, there are mainly three methods used to construct geological models: pouring, tamping, and small block masonry. However, several disadvantages arise when using these artificial methods, including consuming too much time and cost, difficulty in guaranteeing uniformity of the density of different layers, most importantly, being unable to simulate detailed tectonic discontinuities, like faults or fissures. In view of the fact that three-dimensional printing (3DP) technology can easily produce complex fractured structures, 3DP technology is introduced to the research of the geomechanical model test. However, what kind of material is suitable to simulate rock mass and how to fabricate fractured rock-like material specimens are still two complicated problems. In this paper, a cement-based material is used to simulate fractured rock-like material specimens. This kind of material is proved to reach low strength and low elastic modulus by adjusting the mix ratio. What’s more, a method to fabricate small block masonry used in geomechanical model test with 3D printing fracture network is proposed. A series of tests are conducted for these 3DP fractured models, and the corresponding results show that their mechanical properties and failure characteristics are consistent with experimental results of other rock specimens with certain similarity, and geomechanical model test. These fundamental experimental investigations demonstrate the potential feasibility and prospects of 3DP technology in geomechanical model test.