Abstract:A new lower tungsten divertor has been developed and installed in the EAST superconducting tokamak to replace the previous graphite divertor with power handling capability increasing from <2 MW m−2 to ∼10 MW m−2, aiming at achieving long-pulse H-mode operations in a full metal wall environment with the steady-state divertor heat flux of ∼10 MW m−2. A new divertor concept, ‘corner slot’ (CS) divertor, has been employed. By using the ‘corner effect’, a strongly dissipative divertor with the local buildup of high neutral pressure near the corner can be achieved, so that stable detachment can be maintained across the entire outer target plate with a relatively lower impurity seeding rate, at a separatrix density compatible with advanced steady-state core scenarios. These are essential for achieving efficient current drive with low-hybrid waves, a low core impurity concentration and thus a low loop voltage for fully non-inductive long-pulse operations. Compared with the highly closed small-angle-slot divertor in DIII-D, the new divertor in EAST exhibits the following merits: (1) a much simpler geometry with integral cassette body structure, combining vertical and horizontal target plates, which are more suitable for actively water-cooled W/Cu plasma facing components, facilitating installation precision control for minimizing surface misalignment, achieving high engineering reliability and lowering the capital cost as well; (2) it has much greater flexibility in magnetic configurations, allowing for the position of the outer strike point on either vertical or horizontal target plates to accommodate a relatively wide triangularity range, δ l = 0.4–0.6, thus enabling to explore various advanced scenarios. A water-cooled copper in-vessel coil has been installed under the dome. Five supersonic molecular beam injection systems have been mounted in the divertor to achieve faster and more precise feedback control of the gas injection rate. Furthermore, this new divertor allows for double null divertor operation and slowly sweeping the outer strike point across the horizontal and vertical target plates to spread the heat flux for long-pulse operations. Preliminary experimental results demonstrate the ‘corner effect’ and are in good agreement with simulations using SOLPS-ITER code including drifts. The EAST new divertor provides a test-bed for the closed divertor concept to achieve steady-state detachment operation at high power. Next step, a more closed divertor, ‘sharp-cornered slot’ divertor, building upon the current CS divertor concept, has been proposed as a candidate for the EAST upper divertor upgrade.

Modification of the divertor particle flux induced by a coherent mode in the HL-2A tokamak

Overview of Hl-2a Experiment Results

OV / 4-5 1 Overview of Experimental Results on the HL-2 A Tokamak

Overview of Experimental Results on the HL-2A Tokamak

OV / 4-3 1 Overview of Experimental Results on HL-2 A

Divertor Power Deposition Control and ELM Mitigation with Supersonic Molecular Beam Injection in the EAST Tokamak

Divertor Heat Flux Mitigation Using Supersonic Molecular Beam Injection in Type-Iii Elmy H Mode Plasmas of Hl-2a Tokamak

Effects Of A Coherent Mode On The Redistribution Of Divertor Particle Flux In Hl-2a H-Mode Plasmas

Physics Design of New Lower Tungsten Divertor for Long-Pulse High-Power Operations in EAST

OV / 4-1 Overview of HL-2 A Experiment Results

Impact of Coherent Mode on Divertor Particle and Heat Flux in a Type I ELMy H Mode Plasma on EAST Tokamak

Upgrade of an Integrated Langmuir Probe System on the Closed Divertor Target Plates in the HL-2A Tokamak

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Analysis of Divertor Heat Flux with Infrared Thermography During Gas Fuelling in the Hl-2a Tokamak

Divertor Detachment of High Β N H-mode Discharges with the HL-2A Closed Divertor Geometry

Divertor footprint modeling due to RMP in HL-2A and role of plasma response

The mechanism research of double strike points of the divertor particle flux in hl-2a ecrh plasmas

Divertor Detachment and Asymmetry in H-mode Operation with an ITER-like Tungsten Divertor in EAST

Effect of the E × B Drift on the Redistribution of the Divertor Particle Flux in the HL-2A ECRH Plasmas

Divertor Asymmetry and Scrape-off Layer Flow in Various Divertor Configurations in Experimental Advanced Superconducting Tokamak

Integration of Full Divertor Detachment with Improved Core Confinement for Tokamak Fusion Plasmas