Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Vibration Suppression of Magnetic Bearing System Based on Active Disturbance Rejection Control with Generalized Integrator Extend State Observer

Active Disturbance Rejection Control for Bearingless Permanent-Magnet Slice Motor Based on Nonlinear Phase-Locked Loop Observer

Synchronous Vibration Suppression of Magnetic Bearing Systems Without Angular Sensors

A Multifrequency Disturbances Identification and Suppression Method for the Self-Sensing AMB Rotor System

Current Vibration Suppression of Magnetic Bearing Systems Based on Phase Shift Generalized Integrator

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

All-coefficient Adaptive Control of Active Magnetic Bearing System Based on Characteristic Model

Improved Active Disturbance Rejection Control for AMB Flywheel System Based on Inverse System

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Multifrequency Vibration Suppression of Magnetic Bearing Systems Applied Variable Step-size Automatic Learning Control

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Vibration Suppression of Active Magnetic Bearing with Rotor Unbalance Control

Vibration Control of Base-Excited Rotors Supported by Active Magnetic Bearing Using a Model-Based Compensation Method

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Vibration Suppression for Magnetically Levitated High-Speed Motors Based on Polarity Switching Tracking Filter and Disturbance Observer

Vibration Suppression of Active Magnetic Bearing System with Precise Frequency Estimation Method

Synchronous Disturbance Suppression of Active Magnetic Bearing Rotor Systems Using Variable Period Adaptive Control Algorithm

Vibration Suppression In Position Servo Systems Via Active Disturbance Rejection Control

Vibration Suppression of Base-Excited Rotors Supported by Active Magnetic Bearings Based on an Augmented Kalman Compensator

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling