Abstract:Wire arc additive manufacturing (WAAM) can be used to repair blades or blisk made of titanium alloy with the advantage of high efficiency and low-cost. In this work, the finite element model of repairing the blade based on the arc heat source was established to investigate it. Results showed that the maximum effect of thermal undercooling appeared when the peak current transformed to the base current (1 Hz or 5 Hz), which will promote the grains refinement with the combination of sufficient constitutional supercooling. Compared to the single-layer deposition, the microstructure in the near-heat affected zone (near-HAZ) of multi-layer deposition changes from the metastable β phases to the extremely fine α phases, which was caused by the repeated thermal cycles.

Effects of Thermal Undercooling and Thermal Cycles on the Grain and Microstructure Evolution of TC17 Titanium Alloy Repaired by Wire Arc Additive Manufacturing