Abstract:The radial and axial vibration signals of a rotating machine are crucial information to understand the machine operation and to diagnose potential faults. Instead of using three single sensors to measure the horizontal, vertical and axial displacements of rotating shafts, a novel non-projection vision-based system was proposed to realize simultaneous measurement of the radial and axial displacements with high accuracy and good reliability using an tailored artificial constant density sinusoidal fringe pattern (CDSFP), which was pasted around the shaft surface and worked as a tri-axial (i.e. the horizontal, vertical and axial) displacement sensor. The measurement principle and setup of the proposed measurement system were well established. The horizontal displacement could be correctly obtained from the fringe period density changes of the CDSFP image sequence recorded by a high-speed camera. Simultaneously, the vertical displacement could be acquired by tracking the centerline of shaft whilst the axial displacement could be obtained by locating the peaks of the cross-correlation sequence of the fringe intensities. A sub-pixel method was employed to improve the displacement resolution of the developed system. The performance of the proposed system was demonstrated by the comparison of the experiments using eddy current sensors. It showed that the proposed method was an effective and accurate technique for real-time tri-axial vibration monitoring of rotating shaft. Experimental results verified the feasibility, effectiveness and good robustness of the proposed methodology, which demonstrated that the proposed system was capable of achieving accurate tri-axial vibration displacements of rotating shaft compared to the commercial eddy current sensor which could only measure one dimensional displacement at each measurement. Therefore, the vision-based tri-axial vibration monitoring system could be recommended for real engineering applications in condition monitoring of rotating shafts. (C) 2018 Elsevier Ltd. All rights reserved.

Three-Dimensional Vibration Measurement of Monocular Vision Based on Composite Feature Pattern

Full-field vibration measurement based on binocular stereo vision and digital speckle image correlation

Binocular vision vibration measurement based on pixel coordinate matching of inner corner points in a chequerboard

Monocular vision based 3D vibration displacement measurement for civil engineering structures

Computer vision based target-free 3D vibration displacement measurement of structures

Three-dimensional translation vibration measurement system based on linear array sensor and composite fringe pattern

Target-free 3D tiny structural vibration measurement based on deep learning and motion magnification

Three-Dimensional Complex Shape Measurement Using Heterodyne Principle With Binocular Stereo Vision

Vibration Measurement Method Based on Point Tracking for Irregular Structures

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

Integrated interferometer for monitoring three-dimensional vibrations by discrete aperture

3-D Structural Vibration Measurement Using Digital Photogrammetry

Free vibration monitoring testing of a stayed-cable model based on binocular vision

Vision-Based Measurement System for Structural Vibration Monitoring and Damage Detection

Vibration Measurement by Spatiotemporal Analysis of Shadow Moiré Fringes

Vision-based measurement system for structural vibration monitoring using non-projection quasi-interferogram fringe density enhanced by spectrum correction method

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

Heterodyne multi-frequency method for 3D profile measurement

Three-Dimensional Digital Image Correlation Based on Speckle Pattern Projection for Non-Invasive Vibrational Analysis

Transverse Vibration Measurement of Beam Structure Using Based on Subpixel-Based Edge Detection and Point Tracking

Modal analysis of beam-like structures using multipoint dynamic testing vision system based on composite fringe pattern