Abstract:Miniature ocean thermal energy conversion (OTEC) unit is an attractive candidate for sustainable energy supply of autonomous ocean observation platforms. Due to the variability of power load, the OTEC remains susceptible to operation under off-design conditions. A miniature ORC-based OTEC unit was developed and constructed. The performance of the unit under design and off-design was experimentally examined. The effects of operating parameters (i.e., pump frequency and turbine frequency) on power generation and thermal efficiency were evaluate using response surface methodology. The results indicate that the unit can produce 0.917 kW net power with a thermal efficiency of 1.46% at 27 °C heat-source temperature and 6 °C cold-source temperature. Off-design steady-state assessment allows a wide operability range of working-fluid flow rate between 0.18 kg/s and 0.28 kg/s for R134a, corresponding to net power varying between −92 W and 166 W, as well as net thermal efficiency varying between −0.25% and 0.31%. Pump frequency is the primary operating variable affecting the unit performance, followed by turbine frequency. The optimal turbine frequency maximizing thermal efficiency increases with pump frequency, varying between 105 and 160 Hz. When the pump frequency is 32 Hz, the optimal turbine frequency is approximately 160 Hz, which corresponds to the maximum net output of 166 W. The current study offers experimental and theoretical supports for the design and operation of ORC-based OTEC unit.

Experimental Study of Maximum Electrical Generating for Ocean Thermal Profiler

Efficiency and Power Density Analysis on Phase Change Material-Based Ocean Thermoelectric Generator for Underwater Vehicle

Performance Study of Energy Conversion System for Ocean Thermal Profiler

Ocean Profiler Power System Driven by Temperature Difference Energy

Experimental Research of an Ocean Thermal Engine with Phase-Change Material

Multiphysics Co-Simulation and Experimental Study of Deep-Sea Hydrothermal Energy Generation System

Numerical and Experimental Study of the Ocean Thermal Energy Capture Process Utilizing Metal Foam–phase-Change Material (PCM) Composites

Experimental Investigation on Thermal Performance of Phase Change Materials–metal Foam Composites in Ocean Thermal Engine

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Numerical Modeling of the MF /PCM Based Ocean Thermal Engine Using OpenFOAM

A Novel Profiler Driven by Tidal Energy for Long Term Oceanographic Measurements in Offshore Areas

Ocean current power generation at low flow velocity for oceanographic instruments

Development and Experiment of A 60 Kw Horizontal-Axis Marine Current Power System

Ocean current power generation technology for underwater turbine

Design and Experimental Study of 50 kW Ocean Thermal Energy Conversion Test Platform Based on Organic Rankine Cycle

Maximum efficiency point tracking for an ocean thermal energy harvesting system

Investigation of Self-Driven Profiler with Buoyancy Adjusting System Towards Ocean Thermal Energy

Simulation of Generation System of Marine Current Turbine with Pressure-maintaining Storage Based on Hydraulic Transmission

Experimental study of a miniature organic Rankine cycle unit using ocean thermal energy

Design and Test of a 600-Kw Horizontal-Axis Tidal Current Turbine

A 25 Kw Stand-alone Horizontal Axis Tidal Current Turbine