Abstract:Abstract This paper presents the performance analysis of the system for real-time reconstruction of the shape of the rigid medical needle used for minimally invasive surgeries. The system is based on four optical fibers glued along the needle at 90 degrees from each other to measure distributed strain along the needle from four different sides. The distributed measurement is achieved by the interrogator which detects the light scattered from each section of the fiber connected to it and calculates the strain exposed to the fiber from the spectral shift of that backscattered light. This working principle has a limitation of discriminating only a single fiber because of the overlap of backscattering light from several fibers. In order to use four sensing fibers, the Scattering-Level Multiplexing (SLMux) methodology is applied. SLMux is based on fibers with different scattering levels: standard single-mode fibers (SMF) and MgO-nanoparticles doped fibers with a 35–40 dB higher scattering power. Doped fibers are used as sensing fibers and SMFs are used to spatially separate one sensing fiber from another by selecting appropriate lengths of SMFs. The system with four fibers allows obtaining two pairs of opposite fibers used to reconstruct the needle shape along two perpendicular axes. The performance analysis is conducted by moving the needle tip from 0 to 1 cm by 0.1 cm to four main directions (corresponding to the locations of fibers) and to four intermediate directions (between neighboring fibers). The system accuracy for small bending (0.1–0.5 cm) is 90 $$\%$$ % and for large bending (0.6–1 cm) is approximately 92 $$\%$$ % .

Fiber Optic Shape Sensor Based on Differential Geometry

Shape sensing using neural network of radial basis function based on Fiber Bragg Grating

Structure shape measurement method based on an optical fiber shape sensor

Fiber Optic Shape Sensors: A comprehensive review

Tapered Optical Fiber Sensing Technology

Shape Sensing with Rayleigh Backscattering Fibre Optic Sensor

Fiber Bragg Grating-Based Shape Sensing: A Review And Perspective

Parallel Transport Frame for Fiber Shape Sensing

Recent research progress of optical fiber sensors based on D-shaped structure

Learning to sense three-dimensional shape deformation of a single multimode fiber

Design and analysis of a fiber-optic sensing system for shape reconstruction of a minimally invasive surgical needle

Fast and High-Precision Shape Sensing based on Dual-Comb Fiber Bragg Grating Array Demodulation

Multicore fiber shape sensing based on optical frequency domain reflectometry parallel measurements

Reconstruction Error Model of Distributed Shape Sensing Based on the Reentered Frame in OFDR.

A Fiber Sensor for Different Curvature Measurement Based on Nano-Erbium-ytterbium Co-Doped Fiber Cascade Structure As Both Source and Sensor

Optical fiber sensor based on helical Fibers: A review

A Vascular Shape Reconstruction Method Based on Multicore FBG Sensing

Shape Sensing Using Two Outer Cores of Multicore Fiber and Optical Frequency Domain Reflectometer

A Three-Dimensional Shape Measurement System Based on Fiber-Optic Image Bundles

Distributed Fiber Deformation Measurement by High-Accuracy Phase Detection in OFDR Scheme

Optical Fiber Shape Reconstruction Algorithm Based on 3D Euler Spiral Model