Abstract:Despite the broad range of navigation, positioning, and timing services offered by the global navigation satellite system (GNSS), its signals are vulnerable to blockage and interference, leading to a degraded performance or even unavailability. In contrast to GNSS, ground-based navigation systems exhibit better layout flexibility and more efficient terrain adaptability in shaded areas, with their additional advantages of accurate station coordinates and the absence of ionospheric delay effects enabling precise point positioning. However, accurate inter-station time synchronization is thought to be necessary for the ground-based precise point positioning. Locata utilizes a proprietary TimeLoc technology for tight time synchronization, allowing the clock difference in the carrier phase measurement equation to be ignored. However, for other ground-based navigation systems, accurate time synchronization requires accurate calibration of equipment delays and thus significantly increases the difficulty of engineering implementation. Herein, we propose a new precise point positioning method that does not rely on accurate inter-station time synchronization. According to this method, the uncalibrated clock difference and the integer carrier phase ambiguity are combined into a new ambiguity parameter, with the ambiguity and position coordinates subsequently solved in two steps. Further, in order to overcome the limitations of the Locata on-the-fly algorithm and the conventional “known-point initialization” method, a new “dynamic key point initialization” method is proposed. Finally, a simulation test and an indoor field trial are conducted, demonstrating that precise point positioning can be achieved by sharing a single clock source without relying on accurate inter-station time synchronization. An atomic clock is not needed and an inexpensive crystal oscillator is sufficient to act as the shared clock. The results of indoor positioning tests reveal real-time centimeter-level accuracy.

Research on Clock Synchronization Method of Multiple UAVs Cooperative Localization

Cooperative Localization for UAV Systems From the Perspective of Physical Clock Synchronization

A High Accuracy Time Keeping Scheme Based on GPS

A Drone Localization System Based On Multiple Time Delays Fusion

The High-Precisiontime System Design of Pico-Satellite Based on GPS Receiver

Precision Joint RF Measurement of Inter-Satellite Range and Time Difference and Scalable Clock Synchronization for Multi-Microsatellite Formations.

Research On Autonomous High-Precision Time Synchronization Method Of Uavs Based On Side-Tone Signal

Frequency-Offset Information Aided Self Time Synchronization Scheme for High-Dynamic Multi-UAV Networks

Precise point positioning for ground-based navigation systems without accurate time synchronization

Distributed and Collaborative Localization for Swarming UAVs

Ultra-Precise Synchronization for TDoA-based Localization Using Signals of Opportunity

Multi-UAV Collaboration and IMU Fusion Localization Method in Partial GNSS-Denied Scenarios

A Linear Regression-Based Methodology to Improve the Stability of a Low-Cost GPS Receiver Using the Precision Timing Signals from an Atomic Clock

Enhanced RSS-based UAV Localization via Trajectory and Multi-base Stations

A Time Synchronization Algorithm Based on Correlation Analysis in GNSS/INS Integrated Navigation

Design and Implementation of a Time Synchronization Method for UOWC Networks

COMPASS Time Synchronization and Dissemination—toward Centimetre Positioning Accuracy

Research on dynamic two-way time synchronization for air-borne pseudo-satellite in wide area for BD navigation satellite

A Satellite Navigation Relative Timing Method for GNSS-R Miniaturized Passive Location Systems

Impacts of satellite clock errors on GPS/BDS/Galileo real-time PPP time transfer

A Precision Clock Synchronization Method of Satellite Constellation Network Based on IEEE 1588 Protocol