Abstract:The assembled hollow-core slab bridge is the most widely used beam bridge in China. With the increasing traffic volume and traffic load in China, the joints of the hollow-core slab bridge are prone to damage. In this paper, a hollow-core slab bridge with locally curved prestressed tendons is proposed. Based on the static load test of a beam with joints taken from the cross section of a hollow-core slab bridge in practical engineering, a finite element nonlinear analysis is used to simulate the test, and the concrete and interface parameters under the correct analysis results are obtained. Finally, the parameters are applied to the three-beam and two-joint hollow-core slab bridge with a span of 10 m and a finite element analysis is carried out to explore the total failure process and performance improvement effect of the prestressed hollow-core slab bridge. The results show that the interface unit method can successfully simulate the new-to-old concrete interface where the joint is in contact with the precast beam segment. Compared with the static load test results, the analysis error of each finite element model is basically within 15%. Compared with the traditional hollow-core slab bridge, the cracking load, through-joint load, and ultimate load of the prestressed hollow-core slab bridge are increased by 50.0%, 91.7%, and 66.7%, respectively. Under the same load, the stress of the U-bar, the relative deflection of both sides of the joint, and the maximum width of the joint of the prestressed hollow-core slab bridge are lower than those of the traditional hollow-core slab bridge. When the ultimate load is reached, the longitudinal crack lengths of the traditional hollow-core slab bridge and the prestressed hollow-core slab bridge are 0.48 L and 0.4 L, respectively, and the damage degree of the prestressed hollow-core slab bridge is lower than that of the traditional hollow-core slab bridge.

Experiment and Study on Bearing Capacity of Actual Prestressed Concrete Hollow Slab Beam Bridge

Field Destructive Testing of a Reinforced Concrete Bridge Deck Slab

Destructive Test Study of a Prestressed Concrete Hollow Slab Beam Bridge

Experimental studies of the bearing capability of a type of steel-concrete composite slab

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Influence of Effective Prestress on Ultimate Bearing Capacity for Large-Span Prestressed Concrete Bridge

Spatial behavior and strengthening analysis of fabricated PC hollow slab beam bridge with hinge joints

Strengthening Experiment of a Hollow Slab Bridge by External Transverse Prestressing

Research on Spatial Effect of Prestressing Force in Long-Span Concrete Bridge

Experimental Study on Residual Bearing Capacity of Existing Prestressed Concrete Hollow Slab Beam

Analysis of Ultimate Loading Capacity of the Prestressed Concrete Curved Bridge

Lateral Load Distribution of Articulated Hollow Slab Beam Bridge Strengthened by Transverse Prestressed Force

Study on Load Transfer Mechanism of Local Curved Prestressed Hollow-Core Slab Bridge

RESEARCH ON STATIC LOAD TEST AND ANALYSIS OF PRESTRESSED CONCRETE BEAM

Full-range Experimental Analysis of Flexural Performance of an Existing PC Hollow Slab

Study on Method of Simulating Spatial Effect of Prestressing Force in Bridge

Evaluation and Reinforcement of Prestressed Concrete Hollow Slab Bridge after Fire Damage

Analysis of Defect Causes of Precast Segmental Prestressed Concrete T-Frame Bridge and its Experimental Study

Stiffness Degradation Characteristics Destructive Testing and Finite-Element Analysis of Prestressed Concrete T-Beam

Dynamic Response of Bridge Approach Treated with Deep-Seated Concrete Slab

Experimental study on failure mechanism of prestressed concrete T girder