Abstract:With the continuous penetration and development of renewable energy power generation, the distributed grid and the microgrid are becoming increasingly important in modern power systems. In distribution networks and the microgrid, the grid impedance is comparatively large and cannot be ignored. Usually, the parallel compensation is used to improve the grid quality. In the grid with parallel compensation, the large phase angle difference between the impedance of the grid-connected inverter and the impedance of the grid at amplitude intersection will result in high frequency resonance (HFR). Because the inverter shows filter characteristics due to limited bandwidth of the controller, the parallel compensation grid, respectively, performs as the capacitance characteristic and inductance characteristic in different high frequency range. Compared with the three-phase, three-wire system, an additional zero-sequence path exists in the three-phase four-wire split capacitor inverter (TFSCI) system, so that the existing high frequency resonance suppression methods will be not effective. Since the zero-sequence component is neglected, HFR will also occur, in addition to the positive-sequence component and the negative-sequence component. Therefore, in order to suppress the high frequency resonance caused by positive-sequence, negative-sequence and zero-sequence components, an impedance reshaping strategy based on current feedback is proposed in this paper. This proposed method can reshape the amplitude and phase of the inverter impedance in a high frequency range without affecting the performance of the fundamental frequency control and ensure that the inverter contains a sufficient phase margin. Additionally, the proposed method can reshape the impedance of TFSCI within a wide frequency range, which makes it able to cope with the challenge of the parallel compensation degree change. Theoretical analysis and experiments verify the availability of the proposed control strategy.

A Frequency Adaptive Repetitive Control for Active Power Filter with 380V/75A SiC-Inverter

A Control Method for the Interleaved Active Power Filter with SiC-MOSFETs

SiC-MOSFET Shunt Active Power Filter Based on Half-Cycle SDFT and Repetitive Control

Shunt Active Power Filter Using SiC-MOSFET with High Accuracy Compensation

High-Performance Resonant Controller For Active Power Filter With Selective Harmonic Compensation

Research on PI and Repetitive Control Strategy for Shunt Active Power Filter with LCL-filter

Frequency Adaptive Repetitive Control of Grid Tied Single-Phase Pv Inverters

Switch control method based on switch table decision of hybrid system composed of APF and TSC

An adaptive repetitive controller based on generic internal model for active power filter in variable-frequency power system

A Simplified Input Filter Capacity Current Compensation Scheme for 360–800 Hz CRM Totem-Pole PFC with Si MOSFETs

High precision compensation for high power Hybrid Active Power Filter based on repetitive control algorithm

SiC-MOSFET Three Phase Unbalance Compensation Device with Interleaved Parallel Structure

A Simple Input Filter Capacitance (IFC) Current Compensation Scheme for CRM Totem-Pole PFC with Si MOSFETs at 800 Hz Line Frequency

Study on Large Power Shunt Active Power Filters with High Compensation Precision

A frequency adaptive strategy for composite current controller of Shunt Active Power Filters

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

Repetitive Control Implementation with Frequency Adaptive Algorithm for Shunt Active Power Filter

Dual-repetitive Control Algorithm for Three-Phase Shunt Active Power Filters

Analysis and Application of Repetitive Control Scheme for Three-Phase Active Power Filter with Frequency Adaptive Capability

High Frequency Resonance Suppression Strategy of Three-Phase Four-Wire Split Capacitor Inverter Connected to Parallel Compensation Grid