Abstract:Highlights • Sub/Sup-SO parameter identification is proposed via tri-spectral line interpolation. • This method obtains wide identification band range and high measurement accuracy. • Parameter identification is proposed for parameters containing Sub-SO and Sup-SO frequencies. • The deviation of parameter identification was less than 1 % in most cases. As the penetration of renewable energy increases to a large scale and power electronic devices become widespread, power systems are becoming prone to synchronous oscillations (SO). This event has a major impact on the stability of the power grid. The recent research has been mainly concentrated on identifying the parameters of sub-synchronous oscillation. Sub/Super synchronous oscillations (Sub/Sup-SO) simultaneously occur, increasing the difficulty in accurately identify the parameters of SO. This work presents a novel method for parameter identification that effectively handles the Sub/Sup-SO components by utilizing the Rife-Vincent window and discrete Fourier transform (DFT) simultaneously. To mitigate the impact of spectral leakage and the fence effect of DFT, we integrate the tri-spectral interpolation algorithm with the Rife–Vincent window. We use the instantaneous data of the phasor measurement unit (PMU) to identify Sub/Sup-SO-related parameters (Sub/Sup-SO damping ratio, frequency, amplitude and phase). First, the spectrum of the Sub/Sup-SO signals is analyzed after incorporating the Rife-Vincent window, and the characteristics of the Sub/Sup-SO signal are determined. Then, the signal spectrum is identified using a three-point interpolation algorithm, and the damping ratio, amplitude, frequency, and phase of the Sub/Sup-SO signals are obtained. In addition, we consider the identification accuracy of the algorithm under various complex conditions, such as the effect of Sub/Sup-SO parameter variations on parameter identification in the presence of a non-nominal frequency and noise. The proposed algorithm accurately identifies the parameters of multiple Sub/Sup-SO components and two Sub-SO components that are in close proximity. Testing with synthetic and real data demonstrates that the proposed algorithm outperforms existing methods in terms of identification accuracy, identification bandwidth, and adaptability.

Full-Parameters Identification Technique of Attenuated Oscillations in Power System Monitoring

Synthetical Modal Parameters Identification Method of Damped Oscillation Signals in Power System

Power system oscillation mode analysis and parameter determination of pss based on stochastic subspace identification

Mode Identification of Power System Low-Frequency Oscillation Based on Measured Signal

Parameter identification method for sub-synchronous oscillation signals in power systems based on improved multi-synchrosqueezing transform and automatic recognition algorithm

Stochastic Subspace Identification for Power System Low Frequency Oscillations Analysis

Low Frequency Oscillation Modal Parameter Identification Based on Natural Excitation Technique

Accurate parameter identification method for coupled sub/super-synchronous oscillations for high penetration wind power systems

Modal Identification of Low-Frequency Oscillations in Power Systems Based on Improved Variational Modal Decomposition and Sparse Time-Domain Method

Identification of Low Frequency Oscillation Modal Based on Sparse Component Analysis

Subsynchronous Oscillation Modal Identification Based on Damping Sine Atomic Decomposition

Improved Subsynchronous Oscillation Parameter Identification with Synchrophasor Based on Matrix Pencil Method in Power Systems

Extracting Inter-Area Oscillation Modes Using Local Measurements and Data-Driven Stochastic Subspace Technique

Interpolated DFT-based Identification of Sub-Synchronous Oscillation Parameters using Synchrophasor Data

The study of low frequency oscillations parameters identification in power system based on improved HHT method

An Improved Interpolated DFT-Based Parameter Identification for Sub-/Super-Synchronous Oscillations with Synchrophasors

A White Noise Excitation Based Identification Method for Low-frequency Oscillation Modal Parameters

Identification of Power System Low Frequency OscillationsWith ISPM and SDM-Prony

A Method for the Identification of Low Frequency Oscillation Modes in Power Systems Subjected to Noise

Application of Adaptive Chirp Mode Decomposition on Parameter Identification of Sub/super‐synchronous Oscillation Signals

A novel SSO parameters identification technique for power grid with high proportion renewable energy using synchrophasor data