Abstract:Metastable state is the most active catalyst state that dictates the overall catalytic performance and rules of catalytic behaviors; however, identification and stabilization of the metastable state of catalyst are still highly challenging due to the continuous evolution of catalytic sites during the reaction process. In this work, operando Sn-119 Mossbauer measurements and theoretical simulations were performed to track and identify the metastable state of single-atom Sn in copper oxide (Sn-1-CuO) for highly selective CO2 electroreduction to CO. A maximum CO Faradaic efficiency of around 98% at -0.8 V (vs. RHE) over Sn-1-CuO was achieved at an optimized Sn loading of 5.25 wt. %. Operando Mossbauer spectroscopy clearly identified the dynamic evolution of atomically dispersed Sn4+ sites in the CuO matrix that enabled the in situ transformation of Sn4+-O-4-Cu2+ to a metastable state Sn4+-O-3-Cu+ under CO2RR conditions. In combination with quasi in situ X-ray photoelectron spectroscopy, operando Raman and attenuated total reflectance surface enhanced infrared absorption spectroscopies, the promoted desorption of *CO over the Sn4+-O-3 stabilized adjacent Cu+ site was evidenced. In addition, density functional theory calculations further verified that the in situ construction of Sn4+-O-3-Cu+ as the true catalytic site altered the reaction path via modifying the adsorption configuration of the *COOH intermediate, which effectively reduced the reaction free energy required for the hydrogenation of CO2 and the desorption of the *CO, thereby greatly facilitating the CO2-to-CO conversion. This work provides a fundamental insight into the role of single Sn atoms on in situ tuning the electronic structure of Cu-based catalysts, which may pave the way for the development of efficient catalysts for high-selectivity CO2 electroreduction.

Determining Intrinsic Stark Tuning Rates of Adsorbed CO on Copper Surfaces

Reaction-induced Iodine Adsorption on Cu Surfaces Facilitates Electrocatalytic CO2 Reduction.

The Hreels and Arups Investigation of Co Adsorption on the Fe/Cu(11o) Bimetallic Surface

Understanding the Effect of Specific Adsorption on Vibrational Stark Effect of Adsorbates on Electrode Surface via Surface Enhanced Spectroscopies

Studies on adsorption system of carbon monoxide on Cs/Ru(1010) surface by using synchrotron radiation

Determination of Site Specific Adsorption Energies of CO on Copper

In Situ Infrared Spectroscopic Evidence of Enhanced Electrochemical CO2 Reduction and C-C Coupling on Oxide-Derived Copper

Direct Spectroscopic Comparison of CO Adsorption over CuOx Prepared In Situ

Operando Spectroscopic Investigations of Copper and Oxide-Derived Copper Catalysts for Electrochemical CO Reduction

Correlating the Experimentally Determined CO Adsorption Enthalpy with the Electrochemical CO Reduction Performance on Cu Surfaces

Influence of CO Adsorption on the Structure of Electric Double Layer on Cu Surface

Lattice Tuning of Copper Single‐Crystal Surface for Electrochemical Carbon Monoxide Coupling Reaction: A Density Functional Theory Simulation

Co2 Reduction On Cu At Low Overpotentials With Surface Enhanced In Situ Spectroscopy

Operando Mossbauer Spectroscopic Tracking the Metastable State of Atomically Dispersed Tin in Copper Oxide for Selective CO<sub>2</sub> Electroreduction

Single Atom Substituents in Copper Surfaces May Adsorb Multiple CO Molecules

Surface Engineering on Commercial Cu Foil for Steering C 2 H 4 /CH 4 Ratio in CO 2 Electroreduction

Understanding the Complementarities of Surface-Enhanced Infrared and Raman Spectroscopies in CO Adsorption and Electrochemical Reduction.

Elucidating electrochemical CO2 reduction reaction processes on Cu(hkl) single-crystal surfaces by in situ Raman spectroscopy

Theoretical investigation of the adsorbate and potential‐induced stability of Cu facets during electrochemical CO2 and CO reduction

Understanding the Effect of Specific Adsorption on the Vibrational Stark Effect of Adsorbates on an Electrode Surface Via Surface Enhanced Spectroscopy

A new insight into the initial step in the Fischer–Tropsch synthesis: CO dissociation on Ru surfaces