Kinetics and Mechanism Comparison Between Cr/Ti‐Based Bimetallic and Ti‐Based Monometallic Catalysts for Ethylene Polymerization

Yi Zhou,Xuelian He,Boping Liu

DOI: https://doi.org/10.1002/mren.202000041

IF: 1.871

2020-01-01

Macromolecular Reaction Engineering

Abstract:Two (SiO2/MgR2/MgCl2)center dot TiCl(x)model catalysts are made by refluxing TiCl(4)with 0.35 wt% Cr modified silica gel/alkyl Mg adducts or silica gel/alkyl Mg adducts, which are named as Cr/Ti-based bimetallic Cat-1 and Ti-based monometallic Cat-2, respectively. The kinetics, active center counting, morphology, and polymer characterizations are studied to disclose the effect of low loading Cr active sites on the Cr/Ti-based bimetallic Cat-1 polymerization under mild conditions. The activity of Cat-1 is 120.4% higher than that of Cat-2, with a 114.1% higher [C*]/[M] value. Morphology results show the Cat-1 fragmentation in the first 3 min is highly accelerated, which helps to release buried clustered Ti sites. Differential scanning calorimetry results show that low-temperature heat absorbing shoulder of polyethylene (PE) from Cat-2 demonstrates the signal of low crystallinity polymer made by Cat-2 during the first 60 s, verifying the fluffy polymer in morphology results. GPC results show PE from Cat-1 has a higherM(w)in the first 3 min while a lowerM(w)in the end. The Cat-1, which release active sites faster, has a highM(w)in the early time. LowerM(w)in the 900 s attributes to the effect of relative lowerM(w)polymer made by Cr sites, compared with Cat-2.