Abstract:The auto-cascade refrigeration cycle (ACRC) is suitable for low temperature refrigeration fields. From the perspective of fractionation purification matching expansion work recovery, a fractionated auto-cascade refrigeration cycle coupled with the two-phase ejector (FACRC-TPE) using environmentally-friendly R1150/R600a is proposed in this paper. In the novel cycle, the two-phase ejector is substituted for the throttle valve at the liquid stream passage from the separator bottom to recover expansion work and cut down the energy consumption, while the fractionation heat exchanger is applied for purification of low boiling point component in the vapor stream from the separator top to boost the cycle exergy efficiency and achieve a refrigeration temperature below −80 °C. The energetic and exergetic analysis methods are used to evaluate and compare the performances of the three cycles, and comparisons of superiority and irreversibility of FACRC-TPE are also made with the unfractionated auto-cascade refrigeration cycle with the two-phase ejector (UACRC-TPE) and the fractionated auto-cascade refrigeration cycle (FACRC). The results show that the cooperative application of the fractionation heat exchanger coupled with the two-phase ejector not only significantly boosts COP of FACRC-TPE and obtains lower refrigeration temperature, but also cuts down the total exergy loss of FACRC-TPE. With R1150 mass fraction varying in the range of 0.29–0.48, the average COP of FACRC-TPE is 10.57% higher than that of UACRC-TPE, and is 15.18% higher than that of FACRC, whereas FACRC-TPE has a lower evaporator inlet temperature of −100.48 °C to −87.96 °C, as compared with UACRC-TPE. In addition, FACRC-TPE obtains the highest exergy efficiency of 32.23%, while the UACRC-TPE exergy efficiency of 26.99% is slightly higher than the FACRC exergy efficiency of 25.19%.

Influence of Internal Heat Exchanger Position on the Performance of Ejector-Enhanced Auto-Cascade Refrigeration Cycle for the Low-Temperature Freezer

Advanced Exergy Analysis on a Modified Auto-Cascade Freezer Cycle with an Ejector

Performance Evaluation of an Ejector Subcooling Refrigeration Cycle with Zeotropic Mixture R290/R170 for Low-Temperature Freezer Applications

Performance Analysis of an Advanced Ejector-Expansion Autocascade Refrigeration Cycle

Theoretical Investigation on the Performance of a Modified Refrigeration Cycle Using Binary Zeotropic Hydrocarbon Mixture R170/R290

Theoretical Analysis of a Double Ejector-Expansion Autocascade Refrigeration Cycle Using Hydrocarbon Mixture R290/R170

Performance Analysis of a Modified Autocascade Refrigeration Cycle with an Additional Evaporating Subcooler

Theoretical investigation on an ejector–expansion refrigeration cycle using zeotropic mixture R290/R600a for applications in domestic refrigerator/freezers

Performance Study of an Enhanced Ejector Refrigeration Cycle with Flash Tank Economizer for Low-Grade Heat Utilization

Performance evaluation on an internal auto-cascade refrigeration cycle with mixture refrigerant R290/R600a

Study on the Performance of a Novel Waste Heat Recovery System at Low Temperatures

Performance Evaluation of a Modified Refrigeration Cycle with Parallel Compression for Refrigerator-Freezer Applications

Performance Analysis of a Modified Zeotropic Mixture (R290/R600) Refrigeration Cycle with Internal Subcooler for Freezer Applications

Thermodynamic Performance Optimization and Analysis of an Auto-Cascade Refrigeration Cycle with Vapor Injection for Ultra-Low Temperature Freezer

Performance Analysis of an Ejector Enhanced Two-Stage Auto-Cascade Refrigeration Cycle for Low Temperature Freezer

Experimental Research on the Pull-Down Performance of an Ejector Enhanced Auto-Cascade Refrigeration System for Low-Temperature Freezer

Thermodynamic Analysis on a Modified Ejector Expansion Refrigeration Cycle with Zeotropic Mixture (r290/r600a) for Freezers

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Experimental Investigation on the Influence of Ejector Geometry on the Pull-Down Performance of an Ejector-Enhanced Auto-Cascade Low-Temperature Freezer

Performance Analysis of a Dual-Ejector Enhanced Two-Stage Auto-Cascade Refrigeration Cycle for Ultra-Low Temperature Refrigeration

Thermodynamic performance of the fractionated auto-cascade refrigeration cycle coupled with two-phase ejector using R1150/R600a at −80 °C temperature level