Abstract:Surface texturing is an effective technology for enhancing lubrication and anti-wear properties through hydrodynamic effects and secondary lubrication. In this study, two types of variable-depth groove textures were designed to enhance the lubrication performance of friction pairs. Based on theoretical analysis, the coefficient of friction (COF), wear characteristics, and triboelectric open-circuit voltages produced by different textures were evaluated in a series of experiments. Using a friction testing setup, scanning electron microscopy, energy dispersive spectrometry, an electrometer (Keithley 6514), Raman spectroscopy, surface microtopography, and lubrication mechanisms were revealed. First, two types of variable-depth groove textures were designed based on computational fluid dynamics. Second, SiC samples with these textures were fabricated using laser surface texturing technology, and ball–disk rotary friction experiments were performed. During the friction tests, the shallow inner and deep outer (SDT) groove textures exhibited a lower COF at medium and low speeds under varying loads. Finally, the lubrication mechanism was attributed to the synergistic effect of four factors: the hydrodynamic effect of the lubricant, enhanced ability of debris expulsion, oxide tribofilms at the interface, and polarization electric field generated at the solid–liquid interfaces between the lubricant and friction pair. The results indicate that the minimum COF of the SDT texture can be reduced to 0.025. These insights offer valuable guidance for design methods and new lubrication mechanisms for enhancing the lubrication and anti-wear properties of friction pairs in mechanical systems.

Study on Tribological Behavior of Grooved-Texture Surfaces under Sand–oil Boundary Lubrication Conditions

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Influence of Synergistic Effect of Cu Particles and Striated Surface Texture on Tribological Properties

Tribological behavior of carbon steel 45 and brass H90 in dry sliding on bearing steel GCr15 in the sand-dust environment

Friction Behavior of a Textured Surface against Several Materials under Dry and Lubricated Conditions

A Pocket-Textured Surface for Improving the Tribological Properties of Point Contact under Starved Lubrication

An Experimental Investigation of Tribological Performance of Triangular Textures in Water Lubrication Regime

Efficiency of surface texturing in the reducing of wear for tests starting with initial point contact

Tribofilm Formation and Friction Reduction Performance on Laser-Textured Surface with Micro-Grooved Structures

Contact and Tribological Study of Micro/Nano Groove Texture on the Surface of Gas Bearing Materials Based on Nanoscale

Investigation of the multi-mode co-lubrication of various adaptive textures under MXenes-enhanced grease

Evaluation of tribological performance for laser textured surfaces with diverse wettabilities under water/oil lubrication environments

Improvement of current-carrying tribological behaviour via laser surface texture

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Study on the Friction-Reducing Mechanisms of Surface Texture Cemented Carbide under Dry Sliding

The effect of groove-textured surface on friction and wear and friction-induced vibration and noise

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Friction and wear properties of textured surface for bearing steel with mango-shaped micro geometries

Effect of Surface Topography on ZDDP Tribofilm Formation During Running-in Stage Subject to Boundary Lubrication

A Design of Partial Textured Surface on Gear Washers for Reducing Friction and Wear under Low Speed and Heavy Load Conditions