Abstract:SO3 in coal-fired flue gas will cause equipment corrosion and the emission of sulfuric acid mist. The performance of injecting the alkaline adsorbent into the flue gas to remove SO3 is affected by the adsorption of SO2 in the flue gas. Taking Ca(OH)(2) as a typical alkaline adsorbent, a model describing the adsorption of SO3 and SO2 by Ca(OH)(2) particles was established, based on the combination of the product island-growth model and the grain model. The parameters in the model were determined by the experimental data of adsorption in the fixed-bed reactor. The adsorption process of a single Ca(OH)(2) particle was studied by numerical simulation. The adsorption of SO3 and SO2 was found to involve two stages: (1) In the early stage when there existed unreacted grain surface in the particle, SO3 and SO2 mainly reacted with the left fresh grain surface. The SO3 adsorption was controlled by internal pore diffusion and surface reaction, in which internal pore diffusion played a major role. The SO3 adsorption showed a shrinking core mode. The SO2 adsorption was controlled by internal pore diffusion and surface reaction and occurred throughout the entire particle. The SO3 adsorption selectivity at the outer surface of the particle was the highest, and decreased with a decreasing dimensionless particle radius R/R-0. (2) In the later stage when the grain surface was completely reacted, the SO3 adsorption was controlled by internal pore diffusion and product-layer diffusion, in which product-layer diffusion played a major role. The SO2 adsorption was controlled by product-layer diffusion. The product-layer diffusion coefficient in the SO3 adsorption process was significantly higher than that of the SO2 adsorption, so SO3 was still significantly adsorbed in the later stage. The adsorption process of Ca(OH)(2) under different particle structure parameters showed that decreasing the particle radius and increasing the particle porosity and specific surface area increased the SO3 removal efficiency as well as the total conversion of Ca(OH)(2). Decreasing the particle radius and the specific surface area and increasing the particle porosity increased the SO3 adsorption selectivity by Ca(OH)(2). When preparing industrial adsorbents, the optimization of the particle porous structure should be given attention. (C) 2021 Elsevier Ltd. All rights reserved.

Research on operation parameters and properties of flue gas on adsorption of As<sub>2</sub>O3 by -Al<sub>2</sub>O<sub>3</sub>: An experiment and simulation study

Research on the removal of As<sub>2</sub>O<sub>3</sub> by -Al<sub>2</sub>O<sub>3</sub> adsorption based on density functional theory

Experiment and mechanism research on gas-phase As2O3 adsorption of Fe2O3/γ-Al2O3

Adsorption of NOxwith NH3on Γ-Al2o3and Its Effects on the Adsorption of As2O3Based on DFT

Experimental Study on the Removal of SO3 from Coal-Fired Flue Gas by Alkaline Sorbent

Arsenic Adsorption Enhancement Performances of Mn-modified Γ-Al2o3 with Flue Gas Constituents Involved.

Numerical analysis of SO 2 removal characteristics in industrial flue gas desulfurization reactor by spray drying adsorption

A deep insight into the role of O2 on As2O3 capture over γ-Al2O3 sorbent: Experimental and DFT study

As2O3 Adsorption Enhancement over Ni-modified Γ-Al2o3 in Complex Flue Gas Constituents

Strengthened arsenic adsorption over Ni-modified gamma-Al2O3 under different operation conditions: An experimental and simulation study

Microscopic Spherical Α-Fe2o3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas under a Wide Temperature Range

Deep insight into the effect of NaCl/HCl/SO2/CO2 in simulated flue gas on gas-phase arsenic adsorption over mineral oxide sorbents

Progress of gaseous arsenic removal from flue gas by adsorption: Experimental and theoretical calculations

Research on As2O3 Adsorption Enhancement Characteristics of Mn-modified Γ-Al2o3

Trace Flue Gas Contaminants Poison Coordinatively Unsaturated Metal–Organic Frameworks: Implications for CO2Adsorption and Separation

Insight into As2O3 adsorption characteristics by mineral oxide sorbents: Experimental and DFT study

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Microscopic Spherical α-Fe 2 O 3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas Under a Wide Temperature Range

Experimental and DFT Studies of Influence of Flue Gas Components on the Interaction between CaO and As during Sludge Combustion

SELECTIVE REDUCTION DENITRIFICATION OF FLUE GAS BY USING CATALYST Ag/Al2O3 AND REDUCING AGENT C3H6

Process Analysis of SO3 Removal by Ca(OH)2 Particles from Flue Gas