Abstract:The frequency response of phase-sensitive optical time-domain reflectometry ($\Phi $ -OTDR) is strictly limited by the repetition rate of the injected sampling pulses in conventional sensing scheme. To fully reconstruct an arbitrary vibration signal, the pulse repetition rate is required to be lower bounded by twice the maximum frequency of the vibration signal according to the Nyquist sampling theorem and at the same time upper bounded by the sensing fiber length to avoid generations of mixed Rayleigh backscattered signals from more than one optical pulse within the sensing fiber, making high-frequency vibration sensing over long distance impossible. In this work, we propose a novel method based on the serial multi-coset sampling (MCS) strategy which can recover sparse broadband vibration signals with sub-Nyquist sampling rates, which is thus able to break through the tradeoff between the measurable vibration frequency bandwidth and the sensing range. Pulses with non-uniform intervals are adopted to realize MCS for the Rayleigh backscattered lights along the entire sensing fiber rather than the traditional uniform pulse train. A continuous to finite (CTF) block is used to determine the active spectrum ranges of the sparse signal. By using a serial MCS sequence with an average sampling rate of 4.8 kHz, both a 4 kHz single-frequency sinusoidal signal and a 0.2 kHz bandwidth chirped signal with a center frequency of 4.6 kHz were sampled and recovered successfully in the simulation. In experiments, a single frequency vibration signal of 15 kHz and a chirped vibration signal with frequency ranging from 15 to 16 kHz were successfully identified and reconstructed over a sensing distance of 4 km using an average sampling rate of 21.6kHz, respectively, which however is not possible in conventional $\Phi $ -OTDR system. Furthermore, accurate identification of a broadband vibration signal with a maximum frequency of 6 kHz over a 10km-long sensing fiber shows that this method is also practically valid in long-distance sensing.

Compression and Enhancement of Multiscale Vibration Signals Based on Φ-OTDR

Pattern Recognition Based on Enhanced Multifeature Parameters for Vibration Events in Φ‐otdr Distributed Optical Fiber Sensing System

Performance enhancement for phase-sensitive OTDR based on multi-spatial resolution analysis

Enhancement of Signal Identification and Extraction in a Φ-OTDR Vibration Sensor

Hilbert–Huang Transform Time-Frequency Analysis in $\phi $ -OTDR Distributed Sensor

Performance Optimization for a Phase-Sensitive Optical Time-Domain Reflectometry Based on Multiscale Matched Filtering

Quantitative Demodulation of Distributed Low-Frequency Vibration Based on Phase-Shifted Dual-Pulse Phase-Sensitive OTDR with Direct Detection

Broadband Vibration Signal Measurement Based on Multi-Coset Sampling in Phase-Sensitive OTDR System

Ultra-Low Frequency Vibration Sensing in Phase-sensitive OTDR using Multi-Scale VMD

The Research on Information Representation of Φ-OTDR Distributed Vibration Signals

High-Frequency Vibration Detection of Phase-Sensitive Optical Time-Domain Reflectometer

High spatial-resolved φ-OTDR system based on differential pulse width sequence technique

A Space-Division Multiplexing Method for Fading Noise Suppression in the Φ-OTDR System

A Space-Division Multiplexing Method for Fading Noise Suppression in the phi-OTDR System

Crosstalk Noise Suppressed for Multi-frequency φ-OTDR Using Compressed Sensing

Ultra-low Sampling Resolution Technique for Heterodyne Phase-Otdr Based Distributed Acoustic Sensing.

Amplitude-modulated pulses based phase-sensitive OTDR in distributed sensing

A Distributed Optical Fiber Sensing System for Synchronous Vibration and Loss Measurement

Fast-recovering Phi-Otdr System Based on Multi-Sideband Pulse Modulation

Performance Optimization For Phase-Sensitive Otdr Sensing System Based On Multi-Spatial Resolution Analysis

Ultra-Low Frequency Vibration Sensing in Long-Distance Phase-Sensitive OTDR Using CEEMDAN