Abstract:This study evaluated the application of a membrane-free photocatalytic fuel cell composed of a TiO2 nanotube array photoanode and a Cu cathode, i.e. TNA-Cu PFC system, for micropollutant removal from water. Significantly enhanced removal of a commonly present aqueous micropollutant 4-chloro-2-methylphenoxyacetic acid (MCPA) was obtained in this TNA-Cu PFC system: the TNA-Cu PFC system achieved better MCPA degradation compared to the conventional photocatalytic method using the same catalyst. In the TNA-Cu PFC system, the MCPA degradation was largely promoted under acidic conditions, indicating this as an important operational condition. The enhancement of MCPA degradation in the TNA-Cu PFC system involved better e(-)/h(+) separation and generation of other oxidants: in conventional photocatalytic process, hydroxyl radicals in liquid phase contributed to 93.7% MCPA degradation while only 2.4% MCPA degradation was mediated by other oxidants like O-center dot(2)-, H2O2, (HO2)-H-center dot; for MCPA degradation in the TNA-Cu PFC system, the contribution of hydroxyl radicals in the liquid phase decreased to 83.6%, while contribution of other oxidants like O-center dot(2)-, H2O2, (HO2)-H-center dot increased to 15.3%. This change in MCPA degradation mechanisms was confirmed via degradation intermediates analysis by LC-MS/MS. The study on the effect of electrolyte concentration suggests that when operated under acidic conditions, addition of electrolyte is not required. The TNA-Cu PFC system was shown to work well in the presence of up to 15 mg/L natural organic matter (originating from two large rivers), high amounts of common inorganic ions, and even in WWTP effluent. The TNA-Cu PFC system also exhibited relatively good stability after several cycles of repeated use. The obtained results demonstrated that this is an adequate system for micropollutant removal from water at various places in the water cycle, i.e. as polisher of WWTP effluents before discharge or for cleaning intake water before producing drinking water.

Sustainable and Continuous Removal of Trimethylamine in a Bio‐photoelectrochemical Reactor Using G‐c 3 N 4 / TiO 2 Photocathode with Power Generation

Significant Enhancement of Micropollutant Photocatalytic Degradation Using a TiO2 Nanotube Array Photoanode Based Photocatalytic Fuel Cell

Efficient Degradation of Trimethylamine in Gas Phase by Petal-Shaped Co-MoS2 Catalyst in the Photo-Electrochemical System

Integrating Anodic Membrane Diffusion/biodegradation with UV Photolysis, Adsorptive Oxidation by Activation of Peroxymonosulfate over Activated Carbon Fiber Based Photo Cathode in One Reactor System for Removing Toluene Gas

Removal of P-Chloroaniline from Polluted Waters Using a Cathodic Electrochemical Ceramic Membrane Reactor

A Novel UV-assisted PEC-MFC System with CeO2/TiO2/ACF Catalytic Cathode for Gas Phase VOCs Treatment

Enhanced 1,2-dichloroethane removal using g-C3N4/Blue TiO2 nanotube array photoanode in microbial photoelectrochemical cells

Removal of Thiophene in Air Stream by Absorption Combined with Electrochemical Oxidation

Combined photoelectrocatalytic microbial fuel cell (PEC-MFC) degradation of refractory organic pollutants and in-situ electricity utilization

Efficient gas phase VOC removal and electricity generation in an integrated bio-photo-electro-catalytic reactor with bio-anode and TiO2 photo-electro-catalytic air cathode.

Design and Construction of a Highly Efficient Photoelectrocatalytic System Based on Dual-Pd/tnas Photoelectrodes for Elimination of Triclosan

Electricity Generation in Fuel Cell with Light and Without Light and Decomposition of Tetracycline Hydrochloride Using G-C3n4/fe0(1%)/tio2 Anode and WO3 Cathode.

A biophotoelectrocatalytic system for pollutant removal based on carbon fiber cloth supported TiO2 photoanode with oxygen vacancy defects and CuO/g-C3N4 photocathode

A visible-light-driven photocatalytic fuel cell/peroxymonosulfate (PFC/ PMS) system using blue TiO<sub>2</sub> nanotube arrays (TNA) anode and Cu-Co-WO<sub>3</sub> cathode for enhanced oxidation of organic pollutant and ammonium nitrogen in real seawater

Treatment of hazardous organic amine wastewater and simultaneous electricity generation using photocatalytic fuel cell based on TiO<sub>2</sub>/WO<sub>3</sub> photoanode and Cu nanowires cathode

Efficient TN Removal and Simultaneous TOC Conversion for Highly Toxic Organic Amines Based on a Photoelectrochemical-Chlorine Radicals Process

Efficient degradation of refractory pollutant in a microbial fuel cell with novel hybrid photocatalytic air-cathode: Intimate coupling of microbial and photocatalytic processes

Static and Continuous Flow Photoelectrocatalytic Treatment of Antibiotic Wastewater over Mesh of TiO2 Nanotubes Implanted with G-C3n4 Nanosheets.

Synergic degradation of 2,4,6-trichlorophenol in microbial fuel cells with intimately coupled photocatalytic-electrogenic anode

Visible Light Responsive Photoassisted Electrocatalytic System Based on CdS NCs Decorated TiO2 Nano-tube Photoanode and Activated Carbon Containing Cathode for Wastewater Treatment

Synchronously degradation of biogas slurry and triphenyltin chloride in microbial fuel cell