Abstract:In order to make the projected scene cover the seeker's field-of-view promptly the conventional projection optical systems used for hardware-in-the-loop simulation test usually depend on the 5 axes flight-motion-simulator. Those flight-motion-simulator tables are controlled via servomechanisms. The servomechanism needs many axis position transducers and many electromechanical devices. The structure and controlling procedure of the system are complicated. It is hard to avoid the mechanical motion and controlling errors absolutely. The target image jitter will be induced by the vibration of mechanical platform, and the frequency response is limited by the structural performance. To overcome these defects a new infrared image simulating projection system for hardware-in-the-loop simulation test is presented in this paper. The system in this paper consists of multiple lenses joined side by side on a sphere surface. Each single lens uses one IR image generator or resistor array etc. Every IR image generator displays special IR image controlled by the scene simulation computer. The scene computer distributes to every IR image generator the needed image. So the scene detected by the missile seeker is integrated and uninterrupted. The entrance pupil of the seeker lies in the centre of the sphere. Almost semi-sphere range scene can be achieved by the projection system, and the total field of view can be extended by increasing the number of the lenses. However, the luminance uniformity in the field-of-view will be influenced by the joint between the lenses. The method of controlling the luminance uniformity of field-of-view is studied in this paper. The needed luminous exitance of each resist array is analyzed. The experiment shows that the new method is applicable for the hardware-in-the-loop simulation test.

Design Of Optical System For Infrared Scene Projection In Cryogenic Environment

Athermal design of long-wave infrared optical system with hybrid refractive/diffractive

Design of Infrared Hybrid Athermal Optical System

Design of A Panoramic Long-Wave Infrared Athermal System

Influence of temperature on infrared optical system and athermal design

Infrared Scene Projection Optical System for Blackbody Micro Cavity Array

Design and Fabrication of Infrared Hybrid Refractive/diffractive Optical System for 3-5Μm Band

Design of Athermalization for Dual-Band Infrared Optical System Based on Harmanic Diffraction

Optical System Design for a Shortwave Infrared Imaging Spectrometer

Infrared scene projector (IRSP) for cryogenic environments based on a light-driven blackbody micro cavity array (BMCA)

Passive Optical Athermalization Design in Infrared Projection Optical System

Athermalization for Mid-wave Infrared Scene Projector Optical System

Optical Design and Test of a Infrared Hyperspectral Imaging System

Design of an Athermalized Projection Optical System for Infrared Target Simulator

Design and experimental study for lens working at both room and low temperature

Design and testing of high contrast ratio MW/LW infrared dual-bands scene simulation system

Design of a Wide Field of View Infrared Scene Projector

Aberration Athermal Design for Infrared Search and Trace Optical System

Optical Design and Athermalization Analysis of Infrared Dual Band Refractive- Diffractive Telephoto Objective

Design of infrared optical system for multi-targets compounded simulation

Optical Design of a Cooled Mid-Wave Infrared Off-Axis Three-Mirror System with a Low F-number and Wide Field of View