Phase Field Model for Hydraulic Fracture Propagation in Porous Medium and Numerical Simulation Analysis of Hydraulic Fracture Propagation in A Layered Reservoir

Yi Liang-Ping,Yang Chang-Xin,Chen Rui,Zhu Jing-Yi,Zhu Xiao-Hua,Yang Zhao-Zhong,Li Xiao-Gang
DOI: https://doi.org/10.1007/s12517-021-07804-x
2021-01-01
Arabian Journal of Geosciences
Abstract:This study proposes a hydraulic fracture extension model based on the phase field method. In this approach, the rock poroelasticity parameter (Biot's coefficient and modulus) changes with the evolution of rock damage; therefore, a phase field evolution equation is derived. When compared with the results obtained from the standard phase field evolution model (the poroelasticity parameter is regarded as constant), the fracture length calculated using the proposed model is shorter, fracture width is larger, and pressure at the injection point calculated using the standard model is approximately 1.9 times that predicted by the proposed model. Based on the proposed model, certain formation and engineering factors may affect the vertical extension of the hydraulic fracture; the corresponding change in the pressure characteristics at the injection point in layered formation was investigated. The simulation results indicate that the hydraulic crack temporarily stops extending when extending towards the interface, resulting in an increase in the pressure at the injection point. The pressure slowly drops only when the hydraulic crack penetrates the barrier layer. The greater the minimum horizontal stress difference between the barrier and center layers, the greater the strength of the barrier layer. Similarly, the smaller the elastic modulus of the barrier layer, the smaller the viscosity of the fracturing fluid and more difficult it is for the hydraulic crack to extend to the barrier layer. Poisson's ratio of the barrier layer and injection rate had little impact on the vertical extension of the hydraulic crack.
What problem does this paper attempt to address?