Asphalt Mixtures Fatigue Life Considering Various Environmental Impacts
Eryk Mączka,Piotr Mackiewicz
DOI: https://doi.org/10.3390/ma16030966
IF: 3.4
2023-01-21
Materials
Abstract:The pavement structure during the colder seasons (winter) or in regions located above sea level is commonly affected and deteriorated by many environmental factors. Two prominent factors are water and frost (weather) or road salt (maintenance). According to the article's literature review, there are only a few studies related to water and frost or road salt impact on mineral asphalt mixes considering fatigue. Most of the tests were performed on mixes containing common road asphalt or only one binder content level was investigated. There are no articles that investigate this problem comprehensively including new asphalt, its content levels, or production technology. Based on the literature review, the main problem regarding degradation impact on mixtures fatigue life was stated. The investigation was performed using two proprietary experimental methods allowing approximates in situ conditions regarding environmental impacts. A dynamic four-point bending fatigue test was applied to evaluate degradation considering fatigue. The investigation was performed using four coarse-graded asphalt mixtures (asphalt concrete AC 22) which differed in binder type (35/50 WMA, 35/50, 25/55-60, and 25/55-80 HIMA), content level (4.24%, 4.03%, 3.82%), and production technology (hot and warm). Regarding the results obtained, the authors proposed a degradation ratio regarding fatigue life variability. Based on the obtained results and ratio used, it was found that both interactions caused a significant fatigue life decrease—in the worst case, over tens of percent. Furthermore, it was found that asphalt mixture resistance to environmental factors depends on binder type, its content level, air void content, and discussed impact. Moreover, asphalt mixtures' susceptibility to degradation (fatigue) is extreme at lower binder content levels and accelerates due to air void content increase. In the article, it was also stated that the highest resistance was reached by a mixture with highly modified asphalt (25/55-80 HIMA). It was also found that the SBS polymer dosage increase in the asphalt matrix enhances asphalt mixture resistance to environmental impacts. The least resistant to the environmental degradation mixture was WMA (35/50 WMA).
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering