Abstract:In offshore renewable energy design procedures, accurate predictions of extreme responses are required in order to design for survivability whilst minimising associated costs. At present, the established method for predicting extreme responses is to conduct a large number of long-duration simulations, which is practical only in cases where the structural behaviour is captured by a computationally efficient linear approach. Many applications, however, will require a nonlinear approach, which significantly increases the computational cost, and hence the time required to analyse a problem. Should high-fidelity numerical approaches be the appropriate analysis tool, the long-duration simulations are likely to be impractical and in many cases infeasible. Laboratory testing can be utilised to address this to some extent, but this still time-consuming and expensive from a financial perspective. Consequently, there has been considerable interest in the use of short design waves as an alternative method for speeding up the design process. Currently, standards advise that short design waves can be utilised in the design of fixed offshore structures, but application to floating offshore structures needs verification before it becomes an established procedure. This study considers application of single and constrained short design waves to a floating hinged-raft wave energy converter using a 1:50 scale physical modelling approach, and compares with equivalent irregular sea states. The single wave approaches considered here are "NewWave" and the "Most Likely Extreme Response" wave, which are derived from the frequency content of the wave spectrum and response spectrum, respectively. The constrained approach considered in this study is the "Conditional Random Response Wave," where the Most Likely Extreme Response wave is embedded within a random short irregular background. Results show that the single wave approaches under-estimate the extreme loading for the hinge-angle and mooring system compared with the irregular and constrained approaches. The discrepancy between single and constrained waves implies that memory effects are non-negligible, and hence it is critical that they are accounted for when utilising short design waves for floating applications.

Long-term Extreme Response Analysis for Semi-Submersible Platform Mooring Systems

Estimation of characteristic extreme response for mooring system in a complex ocean environment

Comparison of environmental contour and response-based approaches for system reliability analysis of floating structures

Oscillatory Responses of a Spatially Random Seabed in the Vicinity of Structures: Validation and Application of the Integrated CFD-SFEM

Uncertainty analysis of extreme mooring loads associated with environmental contours and peak tension distributions

Hybrid Analysis Approach for Stochastic Response of Offshore Jacket Platforms

Integrated Numerical Investigation of a 15 MW Semi-Submersible Wind Turbine at Moderate Water Depth

System reliability analysis of mooring system for floating offshore wind turbine based on environmental contour approach

An ULS reliability-based design method for mooring lines using an efficient full long-term approach

Fatigue Analysis on Key Components of Semi-Submersible Platform

Assessing Air-Gap Responses of Semi-Submersible Platforms in Extreme Sea States Based on In-Situ Measurement

Simplified Strength Assessment for Preliminary Structural Design of Floating Offshore Wind Turbine Semi-Submersible Platform

Response Extremes of Floating Offshore Wind Turbine Based on Inverse Reliability and Environmental Contour Method

A multi-load joint distribution model to estimate environmental design parameters for floating structures

Experiment-based coupled dynamic analysis of submerged production platform-mooring system in internal solitary waves

A new metamodel for predicting the nonlinear time-domain response of offshore structures subjected to stochastic wave current and wind loads

System Reliability-Based Assessment On Single Point Mooring Jacket Platform

Laboratory investigation on short design wave extreme responses for floating hinged-raft wave energy converters

Numerical investigation on the dynamic response of the semi-submersible aquaculture platform in regular waves

Comparison of 3-D contouring methodologies through the study of extreme tension in a mooring line of a semi-submersible

Application of the Contour Line Method for Estimating Extreme Responses in the Mooring Lines of a Two-Body Floating Wave Energy Converter