Abstract:Wearable ink-based thin-film thermoelectric generator (TEG) is an attractive technology for harvesting human-body waste heat and powering wearable sensors due to its advantages of good flexibility, low cost, and easy manufacture, etc. Revealing performance limits of the wearable TEG is crucial for applicability assessment and optimal device design; however, there is a lack of comprehensive and accurate performance analysis regarding material properties, geometrical parameters, and environmental factors. In this study, a well-validated three-dimensional Multiphysics field coupled numerical model is established to demonstrate the performance of a typical wearable TEG configuration, namely ink-based thin-film thermocouples connected with both-side heat dissipation fins and sandwiched by upper and lower insulation substrates. In the model, different thermoelectric materials (nano-carbon BiTe and pure BiSeTe), different insulation substrates (organic aerogel, PDMS and Kapton), different load electrical resistances, and various environmental and geometrical parameters, are considered. The results show that, (1) the thermal conductance of insulation substrates results in significant performance degradation (about one order of magnitude), indicating that previous used adiabatic condition of substrates has overestimated the TEG performance; (2) human-body thermal resistance, skin-surface contact thermal resistance, and wide-range air velocity have significant influence on TEG performance, which differ much with previous predictions under the condition of adiabatic substrates; (3) the preferred thickness ratio between upper and lower substrates is 7/8-3/2; (4) as the thickness of the whole TEG increases, the optimal thickness ratio between thermocouple and substrate decreases significantly, while the optimal thermocouple thickness is about 0.51-0.55 mm; (5) the maximum output power can reach 0.1 mu W/cm2 under optimized design conditions and suitable TEG thickness. In addition, general optimal design criteria and multi-objective optimization of the TEG are discussed and presented.

Degeneration of Power Output of a Flexible and Wearable Thermoelectric Module under Bending Fatigue

An Analytical Model to Evaluate Influence of Negative Poisson’s Ratio Architecture on Fatigue Life and Energy Conversion Performance of Wearable Thermoelectric Generator

Comprehensive Performance Prediction and Power Promotion for Wearable Thermoelectric Generator with Flexible Encapsulation in Practical Application

Energy Conversion Performance Optimization and Strength Evaluation of a Wearable Thermoelectric Generator Made of a Thermoelectric Layer on a Flexible Substrate

Wearable thermoelectric generator for harvesting heat on the curved human wrist

Thermally Induced Vibration and Strength Failure Analysis of Thermoelectric Generators

Performance Limits of Wearable Ink-Based Thin-Film Thermoelectric Generator for Human-Body Waste Heat Recovery

Theoretical Model of Fatigue Crack Growth of a Thermoelectric Pn-Junction Bonded to an Elastic Substrate

Design and Fabrication of Wearable Thermoelectric Generator Device for Heat Harvesting

Design of flexible inorganic thermoelectric devices for decrease of heat loss

Design of a Wearable Thermoelectric Generator for Harvesting Human Body Energy

Numerical Modeling of the Performance of Thermoelectric Module with Polydimethylsiloxane Encapsulation

Bending Strength Evaluation and Power Generation Performance Optimization of a Curved Photovoltaic-Thermoelectric Hybrid Device

Lifetime Prediction of Thermoelectric Devices under Thermal Cycling

Recyclable, Healable, and Stretchable High‐Power Thermoelectric Generator

Numerical analysis of thermoelectric power generation coupled with temperature-dependent material properties

Temperature and Performance Modeling of Thermoelectric Generators

High-Performance Wearable Bi2Te3-Based Thermoelectric Generator

Finite Element Analysis and Design of a Flexible Thermoelectric Generator with a Rhombus Gap Structure

Optimized thermal design for excellent wearable thermoelectric generator

An Analytical Model for Performance Prediction and Optimization of Thermoelectric Generators with Varied Leg Cross-Sections