Abstract:In urban subsurface exploration, seismic surveys are mostly conducted along roads where seismic vibrators can be extensively used to generate strong seismic energy due to economic and environmental constraints. Generally, Rayleigh waves also are excited by the compressional wave profiling process. Shear-wave (S-wave) velocities can be inferred using Rayleigh waves to complement near-surface characterization. Most vibrators cannot excite seismic energy at lower frequencies (<5 Hz) to map greater depths during surface-wave analysis in areas with low S-wave velocities, but low-frequency surface waves ([Formula: see text]) can be extracted from traffic-induced noise, which can be easily obtained at marginal additional cost. We have implemented synthetic tests to evaluate the velocity deviation caused by offline sources, finding a reasonably small relative bias of surface-wave dispersion curves due to vehicle sources on roads. Using a 2D reflection survey and traffic-induced noise from the central North China Plain, we apply seismic interferometry to a series of 10.0 s segments of passive data. Then, each segment is selectively stacked on the acausal-to-causal ratio of the mean signal-to-noise ratio to generate virtual shot gathers with better dispersion energy images. We next use the dispersion curves derived by combining controlled source surveying with vehicle noise to retrieve the shallow S-wave velocity structure. A maximum exploration depth of 90 m is achieved, and the inverted S-wave profile and interval S-wave velocity model obtained from reflection processing appear consistent. The data set demonstrates that using surface waves derived from seismic reflection surveying and traffic-induced noise provides an efficient supplementary technique for delineating shallow structures in areas featuring thick Quaternary overburden. Additionally, the field test indicates that traffic noise can be created using vehicles or vibrators to capture surface waves within a reliable frequency band of 2–25 Hz if no vehicles are moving along the survey line.

Measurement of high-speed rail surface-wave phase-velocity dispersion

Doppler effect in high-speed rail seismic wavefield and its application

Ultrasonic Dynamic Plane Wave Imaging for High-Speed Railway Inspection

Investigation and Use of Surface-wave Characteristics for Near-surface Applications

Theoretical analysis of high-speed rail seismic imaging

Retrieval of surface waves from high-speed-train-induced vibrations using seismic interferometry

Theoretical Analysis of Generating Virtual Seismic Gatherings Through High-Speed Rail-Induced Subsurface Seismic Wave Fields

Extraction of Rayleigh, Love, and Virtual Refraction Waves from 3C High-Speed-Train-Induced Vibrations for Near-Surface Characterization.

Enhancing Noise Sources in Stationary-Phase Zones for Accurate Phase-Velocity Estimation of High-Frequency Surface Waves

Theoretical Analysis on the Characteristics of Seismic Wave Field Produced by High-Speed Train

A Theoretical Investigation on Characteristic Frequencies of Ground Vibrations Induced by Elevated High Speed Train

Spectral Characteristics of High-Speed Rail Seismic Signal under Viaduct

Imposing Active Sources During High-Frequency Passive Surface-Wave Measurement

On the Surface Waves Retrieved from High-speed Trains Running on Viaducts and Ground Surface

Surface Wave Dispersion Measurement with Polarization Analysis Using Multicomponent Seismic Noise Recorded by a 1-D Linear Array

Interferometry imaging using high-speed-train induced seismic waves

Measurement-Based Delay and Doppler Characterizations for High-Speed Railway Hilly Scenario

Calculation of rayleigh-wave phase velocities due to models with a high-velocity surface layer

Extraction of Characteristics of Wavefield under Viaduct Produced by High-Speed Rail

Common-midpoint Two-Station Analysis of Estimating Phase Velocity Using High-Frequency Ambient Noise

Retrieval of shallow S-wave profiles from seismic reflection surveying and traffic-induced noise