Test And Simulation For The Airtightness Of Backdraft Dampers In Residential Cooking Exhaust Shaft Systems

Yingxia Yang,Zhichao Wang,Xiaofeng Li,Honglei Wang,Yujie Ren,Dan Zhao,Zhaowei Xu
DOI: https://doi.org/10.1016/j.jobe.2021.103007
IF: 7.144
2021-01-01
Journal of Building Engineering
Abstract:PM2.5 emissions from cooking are harmful to human health, and kitchen ventilation is an effective method to reduce the PM2.5 concentration. Cooking exhaust shaft system is a ventilation system widely used in kitchens of residential buildings. However, there is a reverse flow of cooking emissions and odor migration in cooking exhaust shaft system because of the air leakage of backdraft dampers. The aim of this paper is to quantify the airtightness of backdraft dampers and their effect on air quality. There are two types of backdraft dampers widely used in residential cooking exhaust shaft system in China. The blade of one type of damper has two bearing points on the frame and the other type of damper has one bearing point. A total of 40 backdraft dampers (20 Two Bearing Points and 20 One Bearing Point dampers) were selected to test airtightness. Test results show that the airtightness of the 40 backdraft dampers varies greatly, with the air leakage ranging from 7 m(3)/(h.m(2)) to 846 m(3)/(h.m(2)) at a static pressure difference of 250 Pa. Of the 40 dampers, only 18 One Bearing Point dampers have air leakage lower than 366 m(3)/(h.m(2)) specified in ASHRAE Standard 90.1-2016. It is recommended that the One Bearing Point dampers should be utilized in the residential cooking exhaust shaft system. Using the poor, medium, and good One Bearing Point dampers in residential cooking exhaust shaft system for different floors, the air leakage of the closed backdraft dampers is simulated, and the result is 0.6 m(3)/h similar to 8.0 m(3)/h with different rates of simultaneous use. These air leakages may cause the PM2.5 concentration in non-cooking kitchens to exceed the WHO Interim Target-1 of 35 mu g/m(3). It is suggested a stricter airtightness standard of backdraft damper should be formulated, and the air leakage of backdraft damper should not be greater than 1/5 of the ASHRAE standard specified value.
What problem does this paper attempt to address?