Abstract:In order to improve the cycle performance of a conventional single-stage autocascade refrigeration cycle (ARC), an auxiliary separator is considered to be introduced. In the modified autocascade refrigeration cycle (MARC), the auxiliary separator located after an expansion device is used to further collect the vapor enriched with low-boiling components. In this case, the MARC enables to improve the cycle performances by utilizing more zeotropic mixture enriched with the low-boiling components to realize a higher evaporation pressure at the given evaporation temperature in the evaporator of the cycle. The performances of the MARC and ARC are compared utilizing energy, exergy and exergo-economic analysis methods, and several important parameters are also discussed in detail. The results indicate that the MARC using zeotropic mixture R290/R170 is feasible and there are obvious improvements in terms of the COP, volumetric refrigeration capacity and exergy efficiency. It is found that compared to the ARC, the COP improvement of MARC can reach up to 16.1%. The exergy efficiency of MARC is increased by 10.23% and the overall cost rate of MARC is decreased by 2.51% under a typical operating condition. In addition, the COP of MARC has a maximum value at given conditions when the mass fraction of R290 at the compressor inlet is around 0.3. In general, the performance characteristics of the proposed cycle demonstrate its potential applications in low-temperature freezers. (C) 2020 Elsevier Ltd and IIR. All rights reserved.

Performance Enhancement Of A Vapor-Compression Cycle With Cold Storage For Freezer Applications

Performance Analysis of a Modified Zeotropic Mixture (R290/R600) Refrigeration Cycle with Internal Subcooler for Freezer Applications

Performance Evaluation of a Modified Refrigeration Cycle with Parallel Compression for Refrigerator-Freezer Applications

Theoretical investigation on an ejector–expansion refrigeration cycle using zeotropic mixture R290/R600a for applications in domestic refrigerator/freezers

Theoretical Investigation on the Performance of a Modified Refrigeration Cycle Using Binary Zeotropic Hydrocarbon Mixture R170/R290

Performance Evaluation of an Ejector Subcooling Refrigeration Cycle with Zeotropic Mixture R290/R170 for Low-Temperature Freezer Applications

Energy and exergy analysis of zeotropic mixture R290/R600a vapor-compression refrigeration cycle with separation condensation

Performance Analysis of an Advanced Ejector-Expansion Autocascade Refrigeration Cycle

Theoretical Study on a Modified Single‐stage Autocascade Refrigeration Cycle with Auxiliary Phase Separator

Performance Analysis of a Modified Autocascade Refrigeration Cycle with an Additional Evaporating Subcooler

Comparative Studies of Ejector-Expansion Vapor Compression Refrigeration Cycles for Applications in Domestic Refrigerator-Freezers

A novel absorption refrigeration cycle

Performance evaluation and energy-saving potential comparison of a heat-powered novel compression-enhanced ejector refrigeration cycle with an economizer

Performance evaluation on an internal auto-cascade refrigeration cycle with mixture refrigerant R290/R600a

Experimental assessment of using phase change materials in vapor compression refrigeration systems for condenser pre-cooling

Performance Study on a Low-Temperature Absorption–compression Cascade Refrigeration System Driven by Low-Grade Heat

Dynamic evaluation of a vapor compression refrigeration cycle combined with a PCM storage tank for improving condenser performance

Proposal and thermodynamic analysis of an ejection-compression refrigeration cycle driven by low-grade heat

Comparative Study on the Energy Performance of Two Different Absorption-Compression Refrigeration Cycles Driven by Low-Grade Heat

Thermodynamic evaluation of two-stage refrigeration cycle with deep intercooling and series-parallel integration of thermal and mechanical compression

Advanced Exergy Analysis on a Modified Auto-Cascade Freezer Cycle with an Ejector