Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Fault Diagnosis For Esp Sensors Using Ls-Svm

Online Fault Diagnosis for Hydraulic Disc Brake System Using Feature Extracted from Model and an Svm Classifier

Fault Diagnosis Based on RS and SVM

Current-carrying Fault Prediction of Electric Equipment Based on Least Squares Support Vector Machine

Research on Online Fault Prediction Model of Electronic Equipment Based on Online Sparse Least Square Support Vector Machine

A Novel Fault Detection, Identification and Prediction Approach for Autonomous Vehicle Controllers Using SVM

Fault Detection and Isolation for Sensors on SUH Based on SVR and Wavelet Transform

Research on Fault Diagnosis of Drive Train in Wind Turbine Based on Emd and Lssvm

Analytical Redundancy Design for Aeroengine Sensor Fault Diagnostics Based on SROS-ELM

An Effective Fault Diagnosis Approach Based on Optimal Weighted Least Squares Support Vector Machine

Fault Diagnosis Based on Fuzzy Support Vector Machine with Parameter Tuning and Feature Selection

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

Radar Fault Diagnosis Based on Wavelet Transformation and LS-SVM

Nonlinear Dynamic System Based on SAE-LDS Model for Fault Diagnosis

Fault Diagnosis of an Autonomous Vehicle With an Improved SVM Algorithm Subject to Unbalanced Datasets

An Improved Pso-Svm Model For Online Recognition Defects In Eddy Current Testing

A fault diagnosis method for analog circuits based on EEMD-PSO-SVM

A Sensor Dynamic Measurement Error Prediction Model Based on NAPSO-SVM

Failure diagnosis of electro-hydraulic servo valve based on SA-PSO-SVM

Sensitivity-Based Fault Detection and Isolation Algorithm for Road Vehicle Chassis Sensors

Fault Diagnosis for Constant Deceleration Braking System of Mine Hoist Based on Principal Component Analysis and Svm