Abstract:In recent decades, remanufacturing has emerged as an effective way to address resource crises and environmental pollution issues. Unlike traditional manufacturing, remanufacturing production is filled with various variable factors, especially in the assembly phase. Due to changes in part types, quality conditions, and assembly methods, the assembly time becomes highly uncertain. Assembly line balancing is a key challenge to achieve the stable operation of remanufacturing system. This study proposes an evaluation method for remanufacturing assembly time and establishes a multi-objective mathematical model for balancing remanufacturing mixed-model assembly (RMMA) line. The evaluation method utilizes the Fuzzy Graphical Evaluation Review Technique (FGERT) network to predict expected assembly time for each operation. The balancing model aims to optimize remanufacturing takt time and comprehensive balance rate (CBR). To effectively solve this model, an adaptive double-layer genetic algorithm (ADGA) is designed, where layer I ensures production efficiency and layer II optimizes assembly line balance. Finally, an assemble example of high-pressure common rail fuel pumps (HCRFP) is used to validate the effectiveness of the proposed method. The results demonstrate notable improvements compared to traditional single-product assembly (TSPA) line in scenarios with workstation numbers 4, 5, 6, and 7. Specifically, the production takt time is reduced by 4.19% to 9.56%, and CBR is enhanced by approximately 50%. Further comparison with three other classic algorithms confirms the superiority of ADGA. Additionally, it is observed that remanufacturability (proportion of remanufactured parts) has a significant impact on assembly performance. As remanufacturability increases, both takt time and CBR increase, reaching their maximum values when remanufacturability is around 0.5.

Real-Time Production Scheduling Method For Automobile Engine Remanufacturing Based On The Internet Of Manufacturing Things

Petri net-based scheduling strategy and energy modeling for the cylinder block remanufacturing under uncertainty

An IoT-enabled simulation approach for process planning and analysis: a case from engine re-manufacturing industry

Integrated remanufacturing scheduling of disassembly, reprocessing and reassembly considering energy efficiency and stochasticity through group teaching optimization and simulation approaches

The Internet of Things enabled manufacturing enterprise information system design and shop floor dynamic scheduling optimisation

An energy-efficient multi-objective integrated process planning and scheduling for a flexible job-shop-type remanufacturing system

Modeling and scheduling for remanufacturing systems with disassembly, reprocessing, and reassembly considering total energy consumption

Energy-aware fuzzy job-shop scheduling for engine remanufacturing at the multi-machine level

An investigation of mixed-model assembly line balancing problem with uncertain assembly time in remanufacturing

Multi-objective optimization of energy-efficient remanufacturing system scheduling problem with lot-streaming production mode

An energy-efficient multi-objective scheduling for flexible job-shop-type remanufacturing system

An ANN-Based Approach for Real-Time Scheduling in Cloud Manufacturing

An integrated approach for remanufacturing job shop scheduling with routing alternatives

Energy-efficiency-oriented Scheduling in Smart Manufacturing

An Ontology-Based Product Modelling Method for Smart Remanufacturing.

A Framework Of Joint Energy Provisioning And Manufacturing Scheduling In Smart Industrial Wireless Rechargeable Sensor Networks

Multiple-objective Optimization of a Reconfigurable Assembly System Via Equipment Selection and Sequence Planning

Integrated intelligent green scheduling of sustainable flexible workshop with edge computing considering uncertain machine state

A Decomposition-Based Approach for Multitask Scheduling with Execution Uncertainty in Industrial Internet of Things

Integrated optimization of real-time order acceptance and flexible job-shop rescheduling with multi-level imperfect maintenance constraints

Mixed-Flow Assembly Line Balancing with Uncertain Assembly times in Remanufacturing