Abstract:In this paper, a novel tri-rotor configuration is proposed with the goal of granting vertical take-off and landing capabilities to a future concept of tiltrotor, fixed-wing, aircraft while minimizing the overall mass of the propulsive system and the amount of aerodynamic drag developed during horizontal flight. The novelty of the presented configuration is related not only to the thrust vectoring capabilities of all three rotors but also to the constraints surrounding the action of the rear rotor, which will be required to provide thrust during both vertical and horizontal flight stages while drawing power from an internal combustion engine fixed inside the aircraft's fuselage. Another distinctive feature of the proposed configuration is related to the 20/80 thrust distribution which exists between the front and rear rotors respectively in vertical flight, unlike the more conventional approach of having all three rotors evenly loaded. The proposed rotorcraft configuration was then translated into a test vehicle which was subjected to several stages of ground and flight testing, with the ultimate goal of evaluating the airworthiness of this multi-rotor configuration as a concept. This process also encompasses the development of a custom flight control firmware in PX4, required to operate not only this vehicle but also any other multi-rotor or Vertical Take-Off and Landing system with such configuration. Finally, a frequency-response based system identification technique is applied to the collected flight data as to obtain a suitable flight dynamics model for future autopilot tuning.

Testing Methods and Experimental Research on Multi-Rotor Lift

Aerodynamic Simulation of a Typical Multirotor e VTOL Aircraft Configuration.

Rotor Cross-Tilt Optimization of Manned Multi-rotor Evtol Aircraft for Yaw Control Efficiency

Large-Sized Multirotor Design: Accurate Modeling with Aerodynamics and Optimization for Rotor Tilt Angle

Rotor Performance Analysis and Modeling of Multirotor Using Wind-Tunnel Test

A High-Performance Structural Aircraft: Modeling And Control

Preliminary Design Method and Prototype Testing of a Novel Rotors Retractable Hybrid VTOL UAV

Study on the Effect of Tilting-Rotor Structure on the Lift of Small Tilt Rotor Aircraft

Wind Tunnel Testing and Analysis of a Rigid, Variable Speed Rotor for eVTOL Applications

Experimental Characterization of a Propulsion System for Multi-rotor UAVs

Experimental Study on Rotor Dynamic Lift Determination for Agricultural Unmanned Aerial Vehicle (Auav)

Control and Flight Test of A Tilt-Rotor Unmanned Aerial Vehicle

Design of the Rotor Wing Flight Testing Platform for Rotor Aircraft

Investigation on the Airworthiness of a Novel Tri-Rotor Configuration for a Fixed Wing VTOL Aircraft

Rotor cross-tilt optimization for yaw control improvement of multi-rotor eVTOL aircraft

Numerical Simulation and Experimental Validation of Small-rotor Aerodynamic Characteristics

A Lifting Wing Fixed on Multirotor UAVs for Long Flight Ranges

Model Flight Test Research on Flight Characteristics of Compound Lifting-Body Aircraft

Research on the Influence of Coaxial Rotor Configuration on the Propulsion of Multi-Rotor UAVs

Theoretical and experimental study of a piezoelectric flapping wing rotor for micro aerial vehicle

Design and Implementation of Multiple-Rotorcraft-flying-robot Testbed