Extraction And Dyeing Propertie Of Tannin From Walnut Green Husk

M. M. Han,C. Y. Wang,F. Wang,M. X. Pang,C. Qu,J. H. Qi
DOI: https://doi.org/10.1088/1755-1315/199/4/042007
2018-01-01
Abstract:Ultrasonic method for the extraction of tannin from walnut green husk was performed. In order to measure the content of tannin, folin-ciocalteu method was employed in this paper. Ultrasonic time, solvent concentration, temperature were selected for the single-factor experiment. By orthogonal experiment, the optimum condition was determined as acetone concentration was 50%, extracting temperature was 55 degrees C, extracting time was 3.5h. In this condition, the actual content of tannin could reach to 27.37mg/g. In this paper, the crude extracts of tannin from walnut green husk was used to dye something. The results had shown that when ferrisulphas was used to as a mordant, the coloring degree would be the deepest. The coloring degree became deeper and deeper with the dyeing time increasing. There was no significant difference in coloring degree between 80 min and 100 min.
What problem does this paper attempt to address?