The Development of A Mems-Based Inertial/Gps System for Land-Vehicle Navigation Applications

Xiaoji Niu,Sameh Nassar,Zainab Syed,Chris Goodall,Naser El-Sheimy
2006-01-01
Abstract:With the development of low-cost inertial sensors and GPS technology, MEMS-based INS/GPS navigation systems are beginning to meet the increasing demands of lower cost, smaller size, and seamless navigation solutions for land vehicles. But there are still two challenges for current MEMS navigation systems before they can be commercialized. The first one is to further reduce the cost of the systems, which is mainly governed by the cost of MEMS gyros (>$10/axis). The second is to improve the accuracy of the systems, especially during GPS signal outages. The Mobile Multi-Sensor Systems (MMSS) Research Group in the University of Calgary developed its prototype MEMS navigation system in 2004 and published preliminary results in 2005. This paper will report further progress of the systems that tried to fulfill the challenges of the current MEMS system. The system cost issue was addressed by introducing the Partial IMU (ParIMU) configuration that consists of only one heading gyro (Gz) and two horizontal accelerometers (Ax and Ay). The system cost can be reduced significantly since the hardware required for two gyros and one accelerometer is eliminated. A universal algorithm based on the concept of pseudo sensors was developed to process the ParIMU signals. Results have shown that the performance has obvious degradation but still can meet the requirements of some applications, especially with additional aiding, (such as non-holonomic constraint). On the other hand, a Backward Smoothing (BS) algorithm (Rauch-Tung-Strieber smoother) was introduced to improve the navigation performance of the MEMS navigation system. Results showed that the BS can reduce the navigation errors significantly; especially the position drifts during GPS signal outages. Of course, this BS can only be applied for post-processing scenarios. Studies in this paper have shown that the ParIMU and the BS are two measures that can well meet the challenges of current MEMS navigation systems to a large extent.
What problem does this paper attempt to address?