Abstract:In land seismic acquisition, the quality of common-shot gathers is severely degraded by wind turbine noise (WTN) when wind turbines are operating continuously in survey areas. The high-amplitude WTN overlaps or even completely submerges the body and surface waves (signals). Through time-space and frequency analysis, three main features of the WTN are observed: (1) it is periodic with nearly constant frequencies over time, (2) it is coherent but exhibits different apparent velocities in space, and (3) it has relatively narrow bands with varying central frequencies. The first feature enables WTN to distort signals from shallow to deep, whereas the latter two features make traditional methods that separate noise and signals based on velocity and frequency differences less effective. To suppress the WTN, we first analyze its formation and propagation mechanism and then develop a WTN simulation model to validate the presented mechanism. Based on our analysis of WTN and signals, we consider common-shot gathers as the linear superpositions of periodic WTN and relatively broadband signals (referred to as low-oscillatory signals). This additive mixture aligns with the feasibility premise of morphological component analysis (MCA). Finally, based on MCA theory, we develop a sparsity-promoting separation method to suppress WTN in common-shot gathers. To implement our separation method, we construct two dictionaries using the tunable Q-factor wavelet transform (TQWT) and the discrete cosine transform (DCT). TQWT and DCT can sparsely represent the oscillating waves (signals) and periodic waves (WTN), respectively. This work contributes to the existing knowledge of WTN separation by modeling the periodicity of WTN and the low-oscillatory behavior of a signal, rather than relying on velocity or frequency differences. Our method is tested on synthetic and field data, and both tests demonstrate its effectiveness in separating WTN and preserving signals.

Separation Of Weak Signal From Severe Background Noise

Removal Of Noise From Weak Dynamic Signals Of Explosion And Shock Test Based On Wavelet

Sound Field Separating on Arbitrary Surfaces Enclosing a Sound Scatterer Based on Combined Integral Equations.

Non-stable Background Suppress in Wavelet Domain of Infrared Image of Sky

Analysis and Denoising of Electric Noise in Phased Array Ultrasonic Testing System

A method for extracting weak impact signal in NPP based on adaptive Morlet wavelet transform and kurtosis

Partial Source Separation from Unknown Correlation Mixture for Eliminating Unknown Periodic Disturbances from Random Measured Signals

Study Of Extracting Group Velocities Of Near-Surface Rayleigh Waves From Ambient Noise

Measurement With Spread Spectrum For Shock Acceleration

A Method for Weak Impact Signal Discrimination Based on Para-Approximate Entropy

Modeling and Sparsity-Promoting Separation of Wind Turbine Noise in Common-Shot Gathers

Study on weak sound signal separation and pattern recognition under strong background noise in marine engineering

Improving the Quality of High-Frequency Surface Waves Retrieved from Ultrashort Traffic-Induced Noise Based on Eigenvalue Selection

Denoising of seismic signals based on empirical mode decomposition-wavelet thresholding

Monochromatic Noise Removal via Sparsity-Enabled Signal Decomposition Method

Improving Data Quality of Three-Component Measurements of Noise in Urban Environments Using Polarization Analysis

Sparsity optimized separation of Ground-roll noise based on morphological diversity of seismic waveform components

Refining of explosion aftershocks at background noise

Signal processing of structural responses to UNDEX and SRS computation

AN EXPERIMENTAL STUDY OF VERTICAL GROUND ACCELERATION INDUCED BY EXPLOSION SEISM

Least-squares decomposition with time-space constraint for denoising microseismic data