Reverse-Engineering Process Of Point Cloud Based On Surfacer And Ug

Pz Yang,P Song
2004-01-01
Abstract:In order to make a reverse engineering process on the point cloud scanning from one part of a car vibration damper, a new method, which is based on Surfacer and UG is proposed. Firstly, we process the point cloud with Surfacer by such operations as sampling, extracting cross section, generating sectional curves and so on. Then, we denoise and optimize the point cloud. After that, we save, the point data in IGES (Initial Graphics Exchange Specification) format. Finally, we process solid modeling and free-form modeling with UG, obtaining the final CAD model. During the process, the number of points reduces from 243951 to 68509 after the sampling, with a sampling rate about 72%, which greatly increases the reverse engineering efficiency. Meanwhile, the data format IGES is used to exchange the data from Surface to UG, which guarantees the rationality and uniqueness of the data exchange. The method proposed in this paper is an effective and applicable approach to the process of point cloud.
What problem does this paper attempt to address?