A Steady-State Short-Hot-Wire Method For Measurement Of Thermal Conductivity Of A Single Carbon Fiber

X Zhang,S Fujiwara,M Fujii
2000-01-01
Abstract:In this paper, the thermal conductivity of a single carbon fiber at different manufacturing conditions is measured using the steady-state short-hot-wire method. This method is based on the heat transfer phenomena of a pin fin attached to a short hot wire. The short hot wire is supplied with a constant direct current to generate a uniform heat flux and its both ends are connected to lead wires and maintained at the initial temperature. The test fiber is attached as a pin fin to the center position of the hot wire at one end and the other end is connected to a hear sink One-dimensional steady-state heat conduction along the hot wire and test fiber is assumed; and the basic equations are analytically solved. From the solutions, the relations among the average temperature rise of the hot wire, the heat generation rate, the temperature at the attached end of the fiber, and heat flux from the hot wire to the fiber are accurately obtained. Based on the relations, the thermal conductivity of the single carbon fiber can be easily estimated when the average temperature rise and the heat generation rate of the hot wire with known thermal properties are measured for the same system. Uncertainty analysis confirms that the present method can be used to measure the thermal conductivity of a carbon fiber within an error of 7%. A comparison between the present results and reference values shows an about 50% difference in maximum for the carbon fiber with a higher thermal conductivity.
What problem does this paper attempt to address?