Abstract:Despite the non-contact underwater explosion phenomena (UNDEX) have been studied for decades and several numerical methods have been proposed in literature, its effects on military structures, especially composite ones, are even nowadays matter of research. In early design phases, it is not always possible to verify the shock resistance of hull structures modelling the whole phenomenon, in which fluid, gas and solid properties must be properly set in a fully coupled fluid-structure interaction (FSI) numerical model. These ones are extremely complex to set, computationally demanding and certainly not suitable for everyday design practice. In this paper, a simplified finite element (FE) model, easy to use in an early design phase, is proposed. Both, the structure and the fluid are simulated. In this approximation, the fluid behaviour is simplified, using special finite elements, available in a commercial software environment. This choice reduces the computational time and numerical efforts avoiding the problem of combining computational fluid dynamics (CFD) and FE domains and equations in a fully coupled fluid-structure interaction model. A typical parallel body block of a minesweeper is modelled, using two-dimensional multi-layered shell elements to properly account for the composite materials behaviour. For the fluid instead, three dimensional volumetric elements, directly coupled to the structural elements, are placed. In addition, the same calculation is performed, modelling separately fluid in the CFD environment and structures in the finite element one. Thus, realizing a fully coupled fluid-structure interaction model. The results obtained by applying both numerical models are compared with the structural response measured on board of a composite ship during a full-scale shock test. The simplified proposed procedure provides results in satisfactory agreement with experiments, allowing the validation of the model. Approximations are discussed and differences with the real phenomenon and fully coupled CFD+FE method are shown, providing a better understanding of the phenomena. Eventually, the modelling strategy has been considered a valuable and cost-effective tool for the concept and preliminary design of composite structures subject to underwater explosions.

Numerical Simulation Of Damage Effect On The Bottom Construction Of A Ship Subjected To Underwater Explosion

Numerical Simulation of Two-Dimensional Dam Failure and Free-Side Deformation Flow Studies

Analysis of Damage Regularity of Single-Shell Submarine Subject to Typical Weapons' Attacking

Numerical simulation analysis of dynamical performance of equipment protecting from ship-bridge collision

Numerical Simulation of Shock Wave Caused by Underwater Blasting

Numerical Simulation of Internal Gaseous Explosion Loading in Large-Scale Cylindrical Tanks with Fixed Roof

Survey on Experimental and Numerical Approaches to Model Underwater Explosions

Numerical Simulation of Dynamic Response of Steel Plate Subjected to Multiple Underwater Explosions

Damage mechanisms of full-scale ship under near-field underwater explosion

A Novel Efficient Method to Evaluate the Dynamic Response of Laminated Plates Subjected to Underwater Shock

Numerical Simulation of Underwater Explosion Based on Material Point Method

Study on critical condition of damage mode of local grillage structure under near-field underwater explosion

Numerical Modeling of Underwater Explosion by One-Dimensional ANSYS-AUTODYN

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Centrifuge Experiment and Numerical Analysis of an Air-Backed Plate Subjected to Underwater Shock Loading

Damage Characteristics of Structure under Underwater Explosion and Bubble Flooding Loads

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Numerical simulation of structural damage subjected to the near-field underwater explosion based on SPH and RKPM

Effects of Connecting Structures in Double-Hulled Water-Filled Cylindrical Shells on Shock Wave Propagation and the Structural Response to Underwater Explosion

Simulation of impact load on ship-platform collision

A Design Approach to Assess Effects of Non-Contact Underwater Explosions on Naval Composite Vessels