Abstract:The long distance road test of automobile is time consuming and not. economical. The multifunction indoor Drive-axle road simulate system achieved actual road test process. The system based on two big diameter roll wheels. The wheels is fixed a series of protrude blocks on its face to simulate impact and vibration from cragged road. The diameter of roll wheel is four meters. The lay of protrude blocks was according to simulation of road. The power condition was realized through vehicle engine and transmission case. The windage and grade resistance were simulate through inertia flywheel and disk model electric eddy dynamometerWhen Drive-axle received bending load, the stress amassed point and defect point tend to germinated crack. The crack enlarged according to the number of cycling. The damage caused by a stress block is constant irrespective of whether block occurred at the start of loading or just before failure. The s-N stress lifespan method is a structural fatigue life prediction method that takes stress cycle as parameter and is applied to lower-stress and higher-cyclic fatigue life prediction.In the strengthen fatigue test, the noise of vehicle engine was impossible for operator The unpredictable loosen of protrude blocks was dangerous. To solve these problems, the remote control system was introduced by CAN bus and serial communication. The Fault detection and diagnosis, inertia loading, engine throttle control and gearshift operate were achieved through remote control. The key function of remote control was alert before crack, monitor and control of test system, automatic halt and saving data after crack.The system processed the test use E road face based on road spectrum. The strengthen coefficient of the system was six. The time of fatigue test was scores of hours. The time was short relative to traditional road test. Through the data analysis of dynamic test system, fatigue reliability and life evaluation can be realized.

The Strengthen Fatigue Test Of Drive-Axle And Its Remote Control