Abstract:Crack growth analysis (CGA) was applied to estimate the cycle life of the high-pressure hydrogen equipment constructed by the practical materials of 4340 (two heats), 4137, 4130X, A286, type 316 (solution-annealed (SA) and cold-worked (CW)), and type 304 (SA and CW) in 45, 85 and 105 MPa hydrogen and air. The wall thickness was calculated following five regulations of the High Pressure Gas Safety Institute of Japan (KHK) designated equipment rule, KHKS 0220, TSG R0002, JB4732, and ASME Sec. VIII, Div. 3. We also applied CGA for four typical model materials to discuss the effect of ultimate tensile strength (UTS), pressure and hydrogen sensitivity on the cycle life of the high-pressure hydrogen equipment. Leak before burst (LBB) was confirmed in all practical materials in hydrogen and air. The minimum K-IC required for LBB of the model material with UTS of even 1500 MPa was 170 MPa . mu in 105 MPa. Cycle life qualified 10(3) cycles for all practical materials in air. In 105 MPa hydrogen, the cycle life by K-IH was much shorter than that in air for two heats of 4340 and 4137 sensitive to hydrogen gas embriftlement (HGE). The cycle life of type 304 (SA) sensitive to HGE was almost above 10(4) cycles in hydrogen, while the cycle life of type 316 (SA and CW) was not affected by hydrogen and that of A286 in hydrogen was near to that in air. It was discussed that the cycle life increased with decreasing pressure or UTS in hydrogen. This behavior was due to that K-IH increased or fatigue crack growth (FCG) decreased with decreasing pressure or UTS. The cycle life data of the model materials under the conditions of the pressure, UTS, K-IH, FCG and regulations in both hydrogen and air were proposed quantitatively for materials selection for high-pressure hydrogen storage.

High Pressure 98 Mpa Multifunctional Steel Layered Vessels For Stationary Hydrogen Storage

DEVELOPMENT OF STRIP WINDING HIGH PRESSURE HYDROGEN STORAGE VESSEL WITH LOW STRESS INNER LINER

Stresses Controllable Analysis and Optimal Design of Unique High Pressure Vessel Applied in Hydrogen Charge Station

Hydrogen Environment Fatigue Test System Development of High Pressure Hydrogen Storage Vessels

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

Light Weight Design Of Multi-Layered Steel Vessels For High-Pressure Hydrogen Storage

Research on Hydrogen Environment Fatigue Test System and Correlative Fatigue Test of Hydrogen Storage Vessel

Structure design of mobile carbon fibre composite material high pressure hydrogen storage vessel

High Pressure Steel Storage Vessels Used in Hydrogen Refueling Station

Experimental Investigation on the Deformation and Damage of Steel Ribbon Wound Vessel for Hydrogen Storage under External Impact and Blast Loading

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Safety and Reliability Analysis of Multifunctional Layered High-pressure Hydrogen Storage Vessels

Multifunctional Multi-layered Stationary Hydrogen Storage Vessels

Design Fatigue Life Evaluation of High-Pressure Hydrogen Storage Vessels Based on Fracture Mechanics

DESIGN AND OPTIMIZATION OF HIGH-PRESSURE HYDROGEN CYLINDERS FOR INTERMODAL CONTAINER TRANSPORTATION

Numerical Study of Hydrogen Leakage and Explosion in Hydrogen Refueling Station with Large Volume Hydrogen Storage Vessels

Dynamic Response and Vibration Modes of Multi-Layer Wound Cylindrical Shell for Hydrogen Storage under External Blast Loading

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Development of High Pressure Gaseous Hydrogen Storage Technologies

Stationary Flat Steel Ribbon Wound Vessels for Storage of High Pressure Hydrogen

Crack Growth Analysis Of High-Pressure Equipment For Hydrogen Storage