Abstract:Carbon nanotubes (CNTs) are considered an advanced form of carbon. They have superior characteristics in terms of mechanical and thermal properties compared to other available fibers and can be used in various applications, such as supercapacitors, sensors, and artificial muscles. The properties of single-walled carbon nanotubes (SWNTs) are significantly affected by geometric parameters such as chirality and aspect ratio, and testing conditions such as temperature and strain rate. In this study, the effects of geometric parameters and temperature on the mechanical properties of SWNTs were studied by molecular dynamics (MD) simulations using the Large-scaled Atomic/Molecular Massively Parallel Simulator (LAMMPS). Based on the second-generation reactive empirical bond order (REBO) potential, SWNTs of different diameters were tested in tension and compression under different strain rates and temperatures to understand their effects on the mechanical behavior of SWNTs. It was observed that the Young’s modulus and the tensile strength decreases with increasing SWNT tube diameter. As the chiral angle increases, the tensile strength increases, while the Young’s modulus decreases. The simulations were repeated at different temperatures of 300 K, 900 K, 1500 K, 2100 K and different strain rates of 1 × 10−3/ps, 0.75 × 10−3/ps, 0.5 × 10−3/ps, and 0.25 × 10−3/ps to investigate the effects of temperature and strain rate, respectively. The results show that the ultimate tensile strength of SWNTs increases with increasing strain rate. It is also seen that when SWNTs were stretched at higher temperatures, they failed at lower stresses and strains. The compressive behavior results indicate that SWNTs tend to buckle under lower stresses and strains than those under tensile stress. The simulation results were validated by and consistent with previous studies. The presented approach can be applied to investigate the properties of other advanced materials.

Molecular Dynamics Simulations of Bending Behavior of Tubular Graphite Cones

Molecular Dynamics Simulation of Chiral Carbon Nanothread Bundles for Nanofiber Applications

Torsional Properties of Spiral Carbon Nanocones

Coupled Thermomechanics Of Single-Wall Carbon Nanotubes

Tensile and bending properties of double-walled carbon nanotubes

Mechanical and Thermal Properties of Graphyne-Coated Carbon Nanotubes: a Molecular Dynamics Simulation on One-Dimensional All-Carbon Van Der Waals Heterostructures

Interfacial Thermal Conductance of Buckling Carbon Nanotubes

Atomistic Simulation of the Torsion Deformation of Carbon Nanotubes

Thermal Properties of Bended Graphene Nanoribbons from Nonequilibrium Molecular Dynamics

Mechanical properties of graphene nanobuds: A molecular dynamics study

Graphene-Nanotube 3d Networks: Intriguing Thermal and Mechanical Properties

Simulation of the Elastic Response and the Buckling Modes of Single-Walled Carbon Nanotubes

Molecular dynamics simulation studies of mechanical properties of different carbon nanotube systems

Two Distinct Buckling Modes In Carbon Nanotube Bending

Atomistic Simulation of the Torsional Buckling of Single-Crystalline GaN Nanotubes

Modeling and Analysis of the Geometry‐Dependent Mechanical and Thermal Properties of Coiled Carbon Nanotubes

Twisting induced by bending of multiwalled carbon nanotubes

Atomistic Simulations of Uniaxial Tensile Behaviors of Single-Walled Carbon Nanotubes

Buckling and Post-Buckling of Single-Wall Carbon Nanocones Upon Bending

Molecular Dynamics Simulations of Effects of Geometric Parameters and Temperature on Mechanical Properties of Single-Walled Carbon Nanotubes

Buckling and postbuckling analysis of single-walled carbon nanotubes in thermal environments via molecular dynamics simulation