Anti-Swinging Input Shaping Control of an Automatic Construction Crane
Santiago Garrido,M. Abderrahim,Antonio Giménez,Ramiro Diez,Carlos Balaguer,S. Garrido,A. Gimenez,R. Diez,C. Balaguer
DOI: https://doi.org/10.1109/tase.2007.909631
IF: 6.636
2008-07-01
IEEE Transactions on Automation Science and Engineering
Abstract:This paper describes the control of an automatic overhead crane for assembly of modular building elements. The automatic system was developed using a commercial full-size crane, which was modified by adding adequate sensors, servomotors, and control strategy. The crane, which maintained its original cables, was converted to a robotic system, and is controlled via a computer-based multiaxes control board. The implemented algorithms solve two main problems of module assembly: 1) precision positioning of large and heavy modules in the order of a few centimeters, and 2) anti-swinging transportation of modules, even in difficult weather conditions (not extreme). The implementation of the anti-swinging control is achieved using the on-line two-dimensional inclinometer measurements and an on-line calculation of input impulse trains. The developed input-shaping control is divided into two phases: straight line motion and external perturbances cancellation. Experimental results of the developed algorithms which demonstrate the effectiveness of the new process are presented. Note to Practitioners—This paper describes the control technique that governs the motion of an automatic gantry crane. The crane is developed to assemble modular building elements automatically to erect multistory buildings. The modules are fitted with adequate conical connectors to ensure the stable assembly and absorb positioning tolerances of the crane. The automatic assembly system was developed using a commercial full-size crane, which was modified by adding adequate sensors and actuators. The crane, which maintained its original cables, was converted to a robotic system, and is controlled via a computer. The implemented algorithms solve two main problems of module assembly: 1) precision positioning of large and heavy modules, and 2) anti-swinging transportation of modules.
automation & control systems