Abstract:Carbon-free LiFe0.5Mn0.5PO4 and carbon-coated LiFe0.5Mn0.5PO4/C cathode materials were prepared by the mechanochemically assisted solid-state synthesis. The influence of the carbon coating on the porous structure, morphology, conductivity, and electrochemical characteristics of the cathode materials was analyzed using scanning electron microscopy (SEM), standard contact porosimetry (MSCP), electrochemical impedance spectroscopy (EIS), galvanostatic cycling, and galvanostatic intermittent titration technique (GITT). It has been shown that the specific surface area of LiFe0.5Mn0.5PO4/C is twice as high as that of LiFe0.5Mn0.5PO4 despite the very low content of carbon (3%). This was explained by a non-additive contribution of carbon and the active cathode material to the total specific surface area of the composite due to an introduction of carbon in the pores of the cathode material. Among the two key characteristics of a porous structure—specific surface area and volumetric porosity—specific surface area has the greatest impact on electrochemistry of LiFe0.5Mn0.5PO4/C. Mathematical modeling of the discharge profiles of LiFe0.5Mn0.5PO4/C was carried out and compared with the experiment. The cathode heating at high currents was evidenced. The temperatures and coefficients of solid-state diffusion were estimated at different currents. The calculated diffusion coefficient corresponds to the experimental one obtained by GITT at room temperature.

Influence Of Carbon Sources On The Preparation Of Li5fe0.8co0.2o4 And Its Electrochemical Performance

Influence of Different Carbon Sources on the Electrochemical Performance of Li2FeSiO4/C Synthesized by Carbothermal Reduction Method

Effects of Different Carbon Sources on the Performance of Olivine LiFePO_4/C Cathode Material

Effects of carbon on the structure and electrochemical performance of Li2FeSiO4 cathode materials for lithium-ion batteries

Electrochemical property of LiFePO4/C composite cathode with different carbon sources

Optimization of Carbon Coatings on LiFePO4: Carbonization Temperature and Carbon Content

Improvement of Electrochemical Performance of LiFePO4 Cathode Materials for Lithium-Ion Battery

Synthesis and Electrochemical Performance of LiFePO4 Cathode Material with Different Coated Carbon Sources

Preparation and electrochemical investigation of Fe-doped lithium-rich layered Li(Li0.21Mn0.54Ni0.125Co0.125)O2 cathode material

Effects of Different Carbon Sources on Performance of Li3 V2(PO4)3/C Composite Cathode Materials

A novel Cu+-doped Li[Fe0.9Cu0.1Li0.1]PO4/C cathode material with enhanced electrochemical properties

STUDY ON SYNTHESIS AND PERFORMANCE OF LiFePO4/C CATHODE MATERIAL FOR LITHIUM BATTERIES

The Influence of Porous Structure on the Electrochemical Properties of LiFe0.5Mn0.5PO4 Cathode Material Prepared by Mechanochemically Assisted Solid-State Synthesis

Effect of F-doping on the properties of LiFePO4-x/3Fx/C cathode materials via wet mechanical agitation-assisted high-temperature ball milling method

Insight into Cobalt-Doping in Li2FeSiO4 Cathode Material for Lithium-Ion Battery

Synthesis And Characterization Of Li(Li0.2mn0.4fe0.2m0.2)O-2 (M=Co, Ni, Cr, Al) Cathode Materials For Li-Ion Batteries

In-situ carbonation synthesis of LiFePO4/C and its electrochemical properties with ferrous gluconate

Structure and electrochemical performance of LiFePO4 cathode materials modified with carbon coating and metal doping

Electrochemical Properties of F-doped LiFePO<SUB>4</SUB>/C Prepared by Solid-state Synthesis: Electrochemical Properties of F-doped LiFePO<SUB>4</SUB>/C Prepared by Solid-state Synthesis

A Solid-State Method for Preparing Cobalt-Doped Li5feo4 Using Fe(No3)(3) As the Iron Source

Preparation and Characterization of N-doped Li2FeSiO4/C Cathode Materials for Lithium Ion Batteries