Abstract:The ignition of timber buildings in the context of wildland-urban interface (WUI) fires has emerged as a significant challenge amidst the backdrop of global climate change. However, to the best knowledge of the authors, little attention was paid to the ignition conditions of wood building materials in WUI fires especially in thermal-fluid coupling environments. This study experimentally investigated the smoldering and flaming ignition characteristics of wood under the coupling effects of thermal radiation and cross winds. Surface temperature, internal temperature, mass loss rates, and time to ignition of wood samples were measured to study their variation with the above factors and the threshold between smoldering and flaming ignition phenomena. The results showed that wood exhibited reduced susceptibility to flaming ignition under low radiant heat flux conditions, and the introduction of cross winds posed more challenges for flaming ignition. In addition, both the critical surface temperature and mass loss rate varied with radiant heat flux and cross-wind speeds, so it was not feasible to determine the occurrence of flaming ignition by any of the two factors directly. This is because the coupling effects of thermal radiation and cross winds would result in a competition between radiant heating and convective cooling on wood surfaces. In light of this fact, two dimensionless quantities, namely Damk & ouml;hler number and heat transfer ratio, were introduced to distinguish between smoldering and flaming ignitions. Damk & ouml;hler number was used as an indicator of the potential for gas-phase flaming ignition, while the heat transfer ratio, namely the ratio of convective heat loss to radiant heat flux, was used to measure the net thermal energy received by wood surfaces. It has been demonstrated that the two quantities were effective to distinguish between smoldering and flaming ignitions from the perspectives of gas and solid phases with 20-40 kW/m(2) in radiant heat flux and 0-1.0 m/s in cross-wind speed. The data and theories disclosed in this study could help predict the ignition behaviors of timber buildings under thermal-fluid coupling conditions, thus providing useful guidance for WUI fire mitigation and control.

Predicting The Wood Ignition Time In Fires With Two Criterions

Experimental Study of the Ignition of Wood Exposed to a Variable Heat Flux

Experimental Study on Relation Between Ignition Time of Wood and Heat Flux Increasing Rate Exposed to Variable Heat Flux

Numerical Simulation of Fire Development in A Single Compartment Based on Cone Calorimeter Experiments

An Integral Model for Wood Auto-ignition under Variable Heat Flux

Experimental and Numerical Investigations on Fire Development in a Timber-Based Compartment with Identification of Characteristic Events

An Experimental Study of the Effect of Spark Energy on Piloted Ignition of Wood

Thermal-balanced integral model for pyrolysis and ignition of wood

Energy Uptake by Wood During the Ignition under External Radiant Heat Flux

Ignition Limits of Pine Wood Building Material under the Coupling Effects of Thermal Radiation and Cross Winds

Experimental Study and Numerical Analysis on the Factors Concerning the Ignition Time of Timber

Accelerant Influence on Combustion Characteristics of Wood Crib Fire

The Ignition Criterion Of Pulverized Coal Flow And Its Experimental Verification

Mathematical Model for Prediction of Pyrolysis and Ignition of Wood under External Heat Flux

Pyrolysis and Spontaneous Ignition of Wood under Time-Dependent Heat Flux

Modelling Bench-Scale Fire on Engineered Wood: Effects of Transient Flame and Physicochemical Properties

A mathematical description of thermal decomposition and spontaneous ignition of wood slab under a truncated-cone heater

Numerical Simulation of Wood Crib Fire Behavior in A Confined Space Using Cone Calorimeter Data

Development of a numerical method for the rapid prediction of ignition performance of biomass particles

Surface Temperature Measurement on Wood Exposed to Time-increasing Heat Fluxes

Mathematical Modeling of Timeto Ignition in the Early Fire Hazard Test