Abstract:Degradation processes involving oxygen evolution significantly limit the performance, reversibility, and capacity of high energy density Li-ion battery (LiB) cathodes. In addition, oxygen evolution processes create hazardous conditions for LiB operation. Despite the importance of these processes, characterization of evolved O 2 with sufficient spatial and temporal versatility is hampered by the complex setups required to perform electrochemical mass spectrometry, the gold standard for evaluating this process. Recently, we introduced a scanning electrochemical microscopy (SECM) approach that enables in-situ, real-time (i.e., few ms temporal resolution), chemically selective detection of O 2 .[1] Measurements were accomplished by positioning an SECM probe (i.e., an Au ultramicroelectrode) near operating cathode surfaces for detecting O 2 via the oxygen reduction reaction (ORR). The superior signal-to-noise of this method enabled the observation of two peaks corresponding to a steady-state evolution at high voltage and a transient O 2 evolution at low voltage on materials such as lithium cobalt oxide (LCO) and NMC electrodes. Here, we expand the capabilities of our technique by incorporating correlated measurements aimed at understanding how oxygen evolution profiles are related to surface electrochemical and mechanical properties. Specifically, we will focus on the use of feedback-mode SECM and the use of reactive mediators to evaluate the changes in the rates of electron transfer measured on materials undergoing O 2 and after structural degradation. Furthermore, the use of electrochemical AFM allows us to measure the mechanical properties of these interfaces, in an attempt to tie the structural changes and the evolution of oxidizing species with the formation of cathode-electrolyte interfaces. Altogether, these multimodal SECM and AFM methods elucidate the manifold chemical, structural, and performance changes underpinning LiB cathode operation. [1] Mishra, A.; Sarbapalli, D.; Hossain, M.S.; Gossage, Z.T.; Li, Z.; Urban, A.; Rodríguez-López, J. Highly Sensitive Detection and Mapping of Incipient and Steady-State Oxygen Evolution from Operating Li-Ion Battery Cathodes via Scanning Electrochemical Microscopy. J. Electrochem. Soc., 2022, 169, 086501. Figure 1

Investigation of Localized Electrochemical Reactivity on a Β-Pbo2 Electrode Using Scanning Electrochemical Microscopy

Micro-area Investigation on Electrochemical Performance Improvement with Co and Mn Doping in PbO2 Electrode Materials

Plasmonic Imaging Of Electrochemical Reactions At Individual Prussian Blue Nanoparticles

Evaluation of local oxygen flux produced by photoelectrochemical hydroxide oxidation by scanning electrochemical microscopy

Patterning of BiVO4 Surfaces and Monitoring of Localized Catalytic Activity Using Scanning Photoelectrochemical Microscopy

Controlling surface wetting in high-alkaline electrolytes for single facet Pt oxygen evolution electrocatalytic activity mapping by scanning electrochemical cell microscopy

Preparation and Characterization of Pbo2 Electrodes from Electro-Deposition Solutions with Different Copper Concentration

A novel Pb/PbO2 electrodes prepared by the method of thermal oxidation-electrochemical oxidation: Characteristic and electrocatalytic oxidation performance

Electrochemical Scanning Probe Microscopy Evaluation of Li-Ion Battery Cathode Degradation through in Situ Oxygen Evolution Measurement and Interfacial Property Characterization

Direct in-situ imaging of electrochemical corrosion of Pd-Pt core-shell electrocatalysts

Recent advances in scanning electrochemical microscopy for probing the sites in electrocatalysts

In-situ growth of zero-valent iron in FeOx/Mn3O4 to improve the surficial redox for high-efficient electrocatalysis of Pb(II)

Local electrochemical characterization of active Mg-Fe materials: from pure Mg to Mg50-Fe composites

Spatial Identification of Mott-Schottky Effect at Electrocatalytic Pd/Metal Oxide Interfaces for the Oxygen Reduction Reaction

Electrochemical Sensing of Zinc Oxide and Peroxide Nanoparticles: Modification with Meso-tetrakis(4-carboxyphenyl) Porphyrin

Fabrication and Electrocatalytic Performance of a Two Dimensional SS-Pbo2 Macroporous Array for Methyl Orange Degradation

Engineering multi-shell Mn-Co oxide for ultrasensitive electroanalysis of Pb(II) in mining subsidence area water with promotion of adsorption and electron mediation: Behaviors and mechanisms of Mn(II)/Mn(III) and Co(II)/Co(III) cycles

Spectrometric Study of Electrochemical CO2 Reduction on Pd and Pd-B Electrodes

Preparation And Characterization Of Pbo2 On Aluminum Substrate

Controllable Electrolysis Reveals the Microscopic Composition of Lead Sulfide Quantum Dots

Fabrication of a Novel PbO2 Electrode with Rare Earth Elements Doping for P-Nitrophenol Degradation