Abstract:Laser Thomson scattering (LTS) is a minimally invasive measurement technique used for determining electron properties in plasma systems. Sheath model closure validation requires minimally invasive measurements of the electron properties that traverse the boundaries between the bulk plasma, the presheath, and the plasma sheath. Several studies have probed the radial properties along the surface of discharge electrodes with laser-based diagnostics and electrostatic probes. These measurements provide valuable insight into the electron properties in this dynamic region. However, sheath model calibration requires plasma property measurements perpendicular to plasma bounding surfaces, in this case, along the electrode normal vector between discharge electrodes. This work presents the development of a discharge plasma cell and laser Thomson scattering system with a measurement volume step of 1 mm normal to plasma bounding surfaces. The laser Thomson scattering measurements are made between a set of discharge electrodes separated by ∼25 mm that are used to generate a pulsed argon plasma. The spatial distribution of electron temperature and density is measured at several discharge voltages between 8 and 20 kV at a pressure of 8 Torr-Ar. It is determined that the system is statistically stationary and resembles a classic DC discharge plasma. The results are some of the first laser diagnostic-based “between electrode” measurements made along the plasma bounding electrode normal vector. A one-dimensional sheath model is applied to determine the near cathode electron properties, and it is determined that the edge of the presheath is probed in the high-voltage cases. As the lengths of the presheath and sheath decrease with decreasing voltage, the region recedes below the closest probed point to the cathode. To improve the performance of the diagnostic, the step size of the interrogation volume should decrease by an order of magnitude from 1 mm to less than 100 μm, and the data acquisition strategy should be revised to increase the signal-to-noise ratio.

Thomson Scattering Measurement of A Collimated Plasma Jet Generated by A High-Power Laser System

Investigation on the electron density and temperature in a nanosecond pulsed helium plasma jet with Thomson scattering

Two-dimensional Thomson scattering in high-repetition-rate laser-plasma experiments

Anomalous plasma acceleration in colliding high-power laser-produced plasmas

Thomson scattering measurements in the krypton plume of a lanthanum hexaboride hollow cathode in a large vacuum test facility

High-Mach Number Collisionless Shock and Photo-Ionized Non-Lte Plasma for Laboratory Astrophysics with Intense Lasers

High resolution Thomson scattering system for steady-state linear plasma sources

Investigations of Laser-Induced Plasma in Air by Thomson and Rayleigh Scattering

Numerical Analysis of Jets Produced by Intense Laser

Laboratory Investigation of Astrophysical Collimated Jets with Intense Lasers

Thomson Scattering Process in Laser-Produced Plasmas

An incoherent Thomson scattering system for measurements near plasma boundaries

Experimental Diagnosis of Plasma Jets by Using X-Ray Laser

Portable Thomson scattering system for temporally resolved plasma measurements under low density conditions

Thomson Scattering Measurements of Heat Flux from Ion-Acoustic Waves in Laser-Produced Aluminum Plasmas.

Development of the Thomson scattering measurement system for cascade arc device with indirectly heated hollow cathode

Collimation of Laser-Produced Proton Beam

Theory of Thomson scattering in inhomogeneous media

Collimation of Energetic Electrons from a Laser-Target Interaction by a Magnetized Target Back Plasma Preformed by a Long-Pulse Laser

Spatially and Spectrally Resolved X-ray Measurements in Intense Laser-Plasma Interactions

High-power laser experiment forming a supercritical collisionless shock in a magnetized uniform plasma at rest