Synthesis Of Cobaltferrite-Dispersed Carbons By Pressure Pyrolysis Of Organometallic Copolymers

S Hirano,T Yogo,K Kikuta,M Takase,M Fukuda
DOI: https://doi.org/10.1246/nikkashi.1991.1261
1991-01-01
NIPPON KAGAKU KAISHI
Abstract:Carbon powders dispersed uniformly with cobaltferrite particles were successfully synthesized by pressure pyrolysis of vinylferrocene-cobaltocene derivative-divinylbenzene in the presence of water below 650-degrees-C at 125 MPa with their high yield and control of morphology of resultant carbon. The amount of cobaltferrite decreased markedly in the carbon matrix formed at 700-degrees-C, since cobaltferrite was reduced to cobalt oxide and wustite by excess carbon. The size of carbon particles was about 0.5-mu-m in diameter at 600-degrees-C and 2.0-mu-m at 700-degrees-C. The morphology of carbon was dependent upon the pyrolysis temperature and the concentration of metal in a starting copolymer. The morphology of carbon changed from coalescing polyhedra to spherulites with increasing pyrolysis temperature from 600-degrees-C to 700-degrees-C. The size of metal oxide particles which were finely dispersed in carbon synthesized at 600-degrees-C was about 30 nm, which increased with pyrolysis temperature. The saturation magnetization and the coercive force of cobaltferrite-dispersed carbon prepared at 600-degrees-C and 125 MPa were 4.8 emu/g and 2 kOe, respectively.
What problem does this paper attempt to address?